rear shock change
Moderator: martauto
-
steve_k
- E30 Zone Team Member

- Posts: 8044
- Joined: Fri May 23, 2008 11:00 pm
- Location: in the vale of mansfield
Right then the time has come to change the rear shocks & springs on the sport.
been reading the guide on the wiki but what i would like to know is, would it be possible to change the rear shocks without having to even touch the diff??
also is it possible to remove the shock & leave the top mount in place?
i only ask as the top mounts where changed a few months ago at the garage & look to still be in good order.
probably a stupid question but i just had to ask.
been reading the guide on the wiki but what i would like to know is, would it be possible to change the rear shocks without having to even touch the diff??
also is it possible to remove the shock & leave the top mount in place?
i only ask as the top mounts where changed a few months ago at the garage & look to still be in good order.
probably a stupid question but i just had to ask.
if it's got t*ts or wheels it's bound to be trouble...............prove me wrong.
getting oral sex off an ugly person is like rock climbing.....don't look down ;)
getting oral sex off an ugly person is like rock climbing.....don't look down ;)
-
Sanchez
- Married to the E30 Zone

- Posts: 7578
- Joined: Sun Apr 17, 2005 11:00 pm
- Location: Sunny Scotland
You go no way near the diff.
Top mounts come off but can be reused no probs.
Top mounts come off but can be reused no probs.
-
sweep
- Married to the E30 Zone

- Posts: 10110
- Joined: Sat Mar 15, 2008 11:00 pm
- Location: spares & repairs in sheffield
Its easy mate remove the top nut on the shocker and the 19mm bolt holding the bottom of the shocker then it will come off ..this will allow the wishbone to drop but remove the 13mm anti roll bar bracket and it will go down further then you can lever the spring out.
-
steve_k
- E30 Zone Team Member

- Posts: 8044
- Joined: Fri May 23, 2008 11:00 pm
- Location: in the vale of mansfield
cheers dude.Sanchez wrote:You go no way near the diff.
Top mounts come off but can be reused no probs.
looks like i know what i'll be doing tomorrow
if it's got t*ts or wheels it's bound to be trouble...............prove me wrong.
getting oral sex off an ugly person is like rock climbing.....don't look down ;)
getting oral sex off an ugly person is like rock climbing.....don't look down ;)
-
capri_rob
- Married to the E30 Zone

- Posts: 9678
- Joined: Tue Feb 19, 2008 11:00 pm
- Location: South Staffordshire
You dont need to touch the diff but you will need to the get each shock and top mount as one unit. Dead easy. 

e30topless said : Proper BMW's have 4 headlights, last of the run was the E30 and E34/E32 anything after that is just complete shite
-
Sanchez
- Married to the E30 Zone

- Posts: 7578
- Joined: Sun Apr 17, 2005 11:00 pm
- Location: Sunny Scotland
just pm'ed you about my wanted thread

-
steve_k
- E30 Zone Team Member

- Posts: 8044
- Joined: Fri May 23, 2008 11:00 pm
- Location: in the vale of mansfield
cheers sweep thats just what i thoughtsweep wrote:Its easy mate remove the top nut on the shocker and the 19mm bolt holding the bottom of the shocker then it will come off ..this will allow the wishbone to drop but remove the 13mm anti roll bar bracket and it will go down further then you can lever the spring out.
if it's got t*ts or wheels it's bound to be trouble...............prove me wrong.
getting oral sex off an ugly person is like rock climbing.....don't look down ;)
getting oral sex off an ugly person is like rock climbing.....don't look down ;)
-
steve_k
- E30 Zone Team Member

- Posts: 8044
- Joined: Fri May 23, 2008 11:00 pm
- Location: in the vale of mansfield
right back at yaSanchez wrote:just pm'ed you about my wanted thread
if it's got t*ts or wheels it's bound to be trouble...............prove me wrong.
getting oral sex off an ugly person is like rock climbing.....don't look down ;)
getting oral sex off an ugly person is like rock climbing.....don't look down ;)
-
Grrrmachine
- E30 Zone Wiki / Team Member

- Posts: 8043
- Joined: Sat Feb 09, 2008 11:00 pm
- Location: Warsaw, Poland
If the Wiki article is that inaccurate, let me know and I'll do what I can to clean it up
'89 325i Touring | Touring Resto Thread | In-Dash Screen install
-
steve_k
- E30 Zone Team Member

- Posts: 8044
- Joined: Fri May 23, 2008 11:00 pm
- Location: in the vale of mansfield
i'll post up on here in a few days when i've got them changed & the bruising has gone downGrrrmachine wrote:If the Wiki article is that inaccurate, let me know and I'll do what I can to clean it up
if it's got t*ts or wheels it's bound to be trouble...............prove me wrong.
getting oral sex off an ugly person is like rock climbing.....don't look down ;)
getting oral sex off an ugly person is like rock climbing.....don't look down ;)
-
Sanchez
- Married to the E30 Zone

- Posts: 7578
- Joined: Sun Apr 17, 2005 11:00 pm
- Location: Sunny Scotland
Rear diff lowering helps to lower the trailing arm for the standard height spring to drop.
You dont have to lower the diff if the springs are lowering springs and if you remove the antiroll bar drop links this should help the trailing arm drop.
Ive change rear springs from standard to lowered without touching the diff.
You dont have to lower the diff if the springs are lowering springs and if you remove the antiroll bar drop links this should help the trailing arm drop.
Ive change rear springs from standard to lowered without touching the diff.
-
steve_k
- E30 Zone Team Member

- Posts: 8044
- Joined: Fri May 23, 2008 11:00 pm
- Location: in the vale of mansfield
well i went out today to have a go at removing the old damper's & springs & like f**k could i get the 19mm bolt on the bottom to move
i tried everything i could, ratchet spanner's, torque wrench set to it's highest (240nm) & still it wouldn't move
in the end i ended up splitting two, yes two 19mm impact drive sockets.
left both sides soacking in penetrating fluid overnight to see if they'll budge tomorrow.
anyone got any ideas on how to get them out if they don't shift?????
i tried everything i could, ratchet spanner's, torque wrench set to it's highest (240nm) & still it wouldn't move
in the end i ended up splitting two, yes two 19mm impact drive sockets.
left both sides soacking in penetrating fluid overnight to see if they'll budge tomorrow.
anyone got any ideas on how to get them out if they don't shift?????
if it's got t*ts or wheels it's bound to be trouble...............prove me wrong.
getting oral sex off an ugly person is like rock climbing.....don't look down ;)
getting oral sex off an ugly person is like rock climbing.....don't look down ;)
-
steve_k
- E30 Zone Team Member

- Posts: 8044
- Joined: Fri May 23, 2008 11:00 pm
- Location: in the vale of mansfield
Forgot to add, the car chose to fight back & bit me
got two nice looking cut's on the back of my hand now
got two nice looking cut's on the back of my hand now
if it's got t*ts or wheels it's bound to be trouble...............prove me wrong.
getting oral sex off an ugly person is like rock climbing.....don't look down ;)
getting oral sex off an ugly person is like rock climbing.....don't look down ;)
-
Sanchez
- Married to the E30 Zone

- Posts: 7578
- Joined: Sun Apr 17, 2005 11:00 pm
- Location: Sunny Scotland
Shouldnt be that difficult. Maybe they never been changed.
If you have a garage near by go round ask them to use their windy guns to undo and do them up again then should be easier when you get home. Ive done that a few times for no charge.
If you have a garage near by go round ask them to use their windy guns to undo and do them up again then should be easier when you get home. Ive done that a few times for no charge.
-
steve_k
- E30 Zone Team Member

- Posts: 8044
- Joined: Fri May 23, 2008 11:00 pm
- Location: in the vale of mansfield
sounds like a planSanchez wrote:Shouldnt be that difficult. Maybe they never been changed.
If you have a garage near by go round ask them to use their windy guns to undo and do them up again then should be easier when you get home. Ive done that a few times for no charge.
they where changed nearly 6 year's ago lol & they also came out last year when the top mounts were changed.
if it's got t*ts or wheels it's bound to be trouble...............prove me wrong.
getting oral sex off an ugly person is like rock climbing.....don't look down ;)
getting oral sex off an ugly person is like rock climbing.....don't look down ;)
-
Sanchez
- Married to the E30 Zone

- Posts: 7578
- Joined: Sun Apr 17, 2005 11:00 pm
- Location: Sunny Scotland
Garage did the top mounts IIRC so will be tight and no doubt a air gun and over torqued.
Heat or air gun will help.
Heat or air gun will help.
-
capri_rob
- Married to the E30 Zone

- Posts: 9678
- Joined: Tue Feb 19, 2008 11:00 pm
- Location: South Staffordshire
Breaker bar with a scaffold pole extension 

e30topless said : Proper BMW's have 4 headlights, last of the run was the E30 and E34/E32 anything after that is just complete shite
-
chh137
- E30 Zone Squatter

- Posts: 1502
- Joined: Mon Apr 18, 2011 11:00 pm
- Location: deepest darkest derbyshire
A good sharp smack or 2 with a 2 lb hammer on the bolt should do the trick
