rear shock change

Need technical Q/A then you're in the right place

Moderator: martauto

steve_k
E30 Zone Team Member
E30 Zone Team Member
Posts: 8044
Joined: Fri May 23, 2008 11:00 pm
Location: in the vale of mansfield

Post Fri Dec 16, 2011 8:51 pm

Right then the time has come to change the rear shocks & springs on the sport.

been reading the guide on the wiki but what i would like to know is, would it be possible to change the rear shocks without having to even touch the diff??

also is it possible to remove the shock & leave the top mount in place?
i only ask as the top mounts where changed a few months ago at the garage & look to still be in good order.

probably a stupid question but i just had to ask.
if it's got t*ts or wheels it's bound to be trouble...............prove me wrong.
getting oral sex off an ugly person is like rock climbing.....don't look down ;)
Sanchez
Married to the E30 Zone
Married to the E30 Zone
Posts: 7578
Joined: Sun Apr 17, 2005 11:00 pm
Location: Sunny Scotland

Post Fri Dec 16, 2011 8:53 pm

You go no way near the diff.

Top mounts come off but can be reused no probs.
Image
sweep
Married to the E30 Zone
Married to the E30 Zone
Posts: 10110
Joined: Sat Mar 15, 2008 11:00 pm
Location: spares & repairs in sheffield

Post Fri Dec 16, 2011 8:55 pm

Its easy mate remove the top nut on the shocker and the 19mm bolt holding the bottom of the shocker then it will come off ..this will allow the wishbone to drop but remove the 13mm anti roll bar bracket and it will go down further then you can lever the spring out.
steve_k
E30 Zone Team Member
E30 Zone Team Member
Posts: 8044
Joined: Fri May 23, 2008 11:00 pm
Location: in the vale of mansfield

Post Fri Dec 16, 2011 8:55 pm

Sanchez wrote:You go no way near the diff.

Top mounts come off but can be reused no probs.
cheers dude.

looks like i know what i'll be doing tomorrow winkeye
if it's got t*ts or wheels it's bound to be trouble...............prove me wrong.
getting oral sex off an ugly person is like rock climbing.....don't look down ;)
capri_rob
Married to the E30 Zone
Married to the E30 Zone
Posts: 9678
Joined: Tue Feb 19, 2008 11:00 pm
Location: South Staffordshire

Post Fri Dec 16, 2011 8:56 pm

You dont need to touch the diff but you will need to the get each shock and top mount as one unit. Dead easy. :D
Image

e30topless said : Proper BMW's have 4 headlights, last of the run was the E30 and E34/E32 anything after that is just complete shite
Sanchez
Married to the E30 Zone
Married to the E30 Zone
Posts: 7578
Joined: Sun Apr 17, 2005 11:00 pm
Location: Sunny Scotland

Post Fri Dec 16, 2011 8:59 pm

just pm'ed you about my wanted thread
winkeye
Image
steve_k
E30 Zone Team Member
E30 Zone Team Member
Posts: 8044
Joined: Fri May 23, 2008 11:00 pm
Location: in the vale of mansfield

Post Fri Dec 16, 2011 9:20 pm

sweep wrote:Its easy mate remove the top nut on the shocker and the 19mm bolt holding the bottom of the shocker then it will come off ..this will allow the wishbone to drop but remove the 13mm anti roll bar bracket and it will go down further then you can lever the spring out.
cheers sweep thats just what i thought :D
if it's got t*ts or wheels it's bound to be trouble...............prove me wrong.
getting oral sex off an ugly person is like rock climbing.....don't look down ;)
steve_k
E30 Zone Team Member
E30 Zone Team Member
Posts: 8044
Joined: Fri May 23, 2008 11:00 pm
Location: in the vale of mansfield

Post Fri Dec 16, 2011 9:24 pm

Sanchez wrote:just pm'ed you about my wanted thread
winkeye
right back at ya :D
if it's got t*ts or wheels it's bound to be trouble...............prove me wrong.
getting oral sex off an ugly person is like rock climbing.....don't look down ;)
Grrrmachine
E30 Zone Wiki / Team Member
E30 Zone Wiki / Team Member
Posts: 8043
Joined: Sat Feb 09, 2008 11:00 pm
Location: Warsaw, Poland

Post Fri Dec 16, 2011 10:05 pm

If the Wiki article is that inaccurate, let me know and I'll do what I can to clean it up
steve_k
E30 Zone Team Member
E30 Zone Team Member
Posts: 8044
Joined: Fri May 23, 2008 11:00 pm
Location: in the vale of mansfield

Post Fri Dec 16, 2011 10:09 pm

Grrrmachine wrote:If the Wiki article is that inaccurate, let me know and I'll do what I can to clean it up
i'll post up on here in a few days when i've got them changed & the bruising has gone down winkeye
if it's got t*ts or wheels it's bound to be trouble...............prove me wrong.
getting oral sex off an ugly person is like rock climbing.....don't look down ;)
Sanchez
Married to the E30 Zone
Married to the E30 Zone
Posts: 7578
Joined: Sun Apr 17, 2005 11:00 pm
Location: Sunny Scotland

Post Fri Dec 16, 2011 10:13 pm

Rear diff lowering helps to lower the trailing arm for the standard height spring to drop.

You dont have to lower the diff if the springs are lowering springs and if you remove the antiroll bar drop links this should help the trailing arm drop.

Ive change rear springs from standard to lowered without touching the diff.
Image
steve_k
E30 Zone Team Member
E30 Zone Team Member
Posts: 8044
Joined: Fri May 23, 2008 11:00 pm
Location: in the vale of mansfield

Post Sat Dec 17, 2011 6:56 pm

well i went out today to have a go at removing the old damper's & springs & like f**k could i get the 19mm bolt on the bottom to move :cursin:

i tried everything i could, ratchet spanner's, torque wrench set to it's highest (240nm) & still it wouldn't move :cursin:

in the end i ended up splitting two, yes two 19mm impact drive sockets.

left both sides soacking in penetrating fluid overnight to see if they'll budge tomorrow.

anyone got any ideas on how to get them out if they don't shift?????
if it's got t*ts or wheels it's bound to be trouble...............prove me wrong.
getting oral sex off an ugly person is like rock climbing.....don't look down ;)
steve_k
E30 Zone Team Member
E30 Zone Team Member
Posts: 8044
Joined: Fri May 23, 2008 11:00 pm
Location: in the vale of mansfield

Post Sat Dec 17, 2011 6:59 pm

Forgot to add, the car chose to fight back & bit me 8O

got two nice looking cut's on the back of my hand now :x
if it's got t*ts or wheels it's bound to be trouble...............prove me wrong.
getting oral sex off an ugly person is like rock climbing.....don't look down ;)
Sanchez
Married to the E30 Zone
Married to the E30 Zone
Posts: 7578
Joined: Sun Apr 17, 2005 11:00 pm
Location: Sunny Scotland

Post Sat Dec 17, 2011 7:00 pm

Shouldnt be that difficult. Maybe they never been changed.

If you have a garage near by go round ask them to use their windy guns to undo and do them up again then should be easier when you get home. Ive done that a few times for no charge.
Image
steve_k
E30 Zone Team Member
E30 Zone Team Member
Posts: 8044
Joined: Fri May 23, 2008 11:00 pm
Location: in the vale of mansfield

Post Sat Dec 17, 2011 7:01 pm

Sanchez wrote:Shouldnt be that difficult. Maybe they never been changed.

If you have a garage near by go round ask them to use their windy guns to undo and do them up again then should be easier when you get home. Ive done that a few times for no charge.
sounds like a plan :D

they where changed nearly 6 year's ago lol & they also came out last year when the top mounts were changed.
if it's got t*ts or wheels it's bound to be trouble...............prove me wrong.
getting oral sex off an ugly person is like rock climbing.....don't look down ;)
Sanchez
Married to the E30 Zone
Married to the E30 Zone
Posts: 7578
Joined: Sun Apr 17, 2005 11:00 pm
Location: Sunny Scotland

Post Sat Dec 17, 2011 7:05 pm

Garage did the top mounts IIRC so will be tight and no doubt a air gun and over torqued.

Heat or air gun will help.
Image
capri_rob
Married to the E30 Zone
Married to the E30 Zone
Posts: 9678
Joined: Tue Feb 19, 2008 11:00 pm
Location: South Staffordshire

Post Sat Dec 17, 2011 7:09 pm

Breaker bar with a scaffold pole extension :twisted:
Image

e30topless said : Proper BMW's have 4 headlights, last of the run was the E30 and E34/E32 anything after that is just complete shite
chh137
E30 Zone Squatter
E30 Zone Squatter
Posts: 1502
Joined: Mon Apr 18, 2011 11:00 pm
Location: deepest darkest derbyshire

Post Sat Dec 17, 2011 7:16 pm

A good sharp smack or 2 with a 2 lb hammer on the bolt should do the trick