oxygen sensor

Need technical Q/A then you're in the right place

Moderator: martauto

aceifty
E30 Zone Regular
E30 Zone Regular
Posts: 866
Joined: Mon Jan 26, 2009 11:00 pm
Location: never you mind

Post Wed Dec 14, 2011 7:18 pm

my m20b28 does not have a oxygen sensor will that make any difference. it was a m20b20 before.

if it needs one how can i put one on?
Last edited by aceifty on Wed Dec 14, 2011 7:41 pm, edited 1 time in total.
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49360
Joined: Mon Jan 10, 2005 11:00 pm

Post Wed Dec 14, 2011 7:39 pm

Your what? "m2b28"?
aceifty
E30 Zone Regular
E30 Zone Regular
Posts: 866
Joined: Mon Jan 26, 2009 11:00 pm
Location: never you mind

Post Thu Dec 15, 2011 10:05 am

Bump
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49360
Joined: Mon Jan 10, 2005 11:00 pm

Post Thu Dec 15, 2011 10:42 am

Brianmoooore wrote:Your what? "m2b28"?
When the question makes sense, you may get a reply!
HairyScreech
Engaged to the E30 Zone
Engaged to the E30 Zone
Posts: 6265
Joined: Sun Jan 21, 2007 11:00 pm

Post Thu Dec 15, 2011 11:46 am

m20b28
2.8 development thread http://www.e30zone.net/modules.php?name ... c&t=170822

m3.3.1 m20 thread - now running, chip needed - any volunteers?
http://www.e30zone.net/modules.php?name ... =viewtopic&
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49360
Joined: Mon Jan 10, 2005 11:00 pm

Post Thu Dec 15, 2011 1:36 pm

Assuming you're using a M20 ECU, it doesn't need a lambda sensor, although it can be used with one. The purpose of the lambda sensor is primarily to protect the catalytic converter from damage, so there's not much point in adding one.
If you do want to add one, you'll need to weld a M16 thin nut to one of the downpipes, and drill a hole into the pipe. Just above the bottom bend on the inner pipe is where I fit them. High enough to be protected from damage, and still accessible.