SI Board Batteries
Moderator: martauto
-
turkeysneck
- E30 Zone Regular

- Posts: 441
- Joined: Sat Nov 27, 2010 11:00 pm
Can anyone tell me where I can buy the batteries that solder onto the Service Indicator Board, ideally is this country.
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
RS Components, or CPC-Farnell.
NiMH batteries can replace NiCd ones, and go for AAA or 2/3AA ones to give you some spare room to attach wire links at the end of the batteries, since I can't find any with the same tag pattern as the originals.
NiMH batteries can replace NiCd ones, and go for AAA or 2/3AA ones to give you some spare room to attach wire links at the end of the batteries, since I can't find any with the same tag pattern as the originals.
-
turkeysneck
- E30 Zone Regular

- Posts: 441
- Joined: Sat Nov 27, 2010 11:00 pm
I presume the best option is to de solder the little tags on both ends of the batteries. Or do you suggest de soldering the tags from the board itself and buying batteries with the tags already fitted to the batteries.
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
You need batteries with tags already on them. They are spot welded to the battery, and are 'tinned' so that solder will flow on them. The batteries themselves are not a solder friendly metal, without a special flux, and the heat will probably damage them anyway.
Solder short pieces of 15A fusewire or similar onto the batteries, then thread the other ends of the wires through the circuit board.
Make sure you know which way around the batteries fit before you remove the old ones.
Solder short pieces of 15A fusewire or similar onto the batteries, then thread the other ends of the wires through the circuit board.
Make sure you know which way around the batteries fit before you remove the old ones.
