I'm converting an early 325 engine to later management and putting it into a 318 shell. I have a remapped chip for a motronic 325, if I put this into a 320 ECU (the engine loom donor is a 320) will it run the 325 Ok?
Cheers
Brian
Chipped 320 ECU in a 325?
Moderator: martauto
-
Brian28
- E30 Zone Squatter

- Posts: 1596
- Joined: Sat Jun 11, 2005 11:00 pm
- Location: Bournemouth
For sale - E30 320i racer project - sold.
-
Grrrmachine
- E30 Zone Wiki / Team Member

- Posts: 8043
- Joined: Sat Feb 09, 2008 11:00 pm
- Location: Warsaw, Poland
As long as the ECU is a Motronic 1.3 (1988 onwards), then you should be fine.
Check your ECU part number here:
http://www.e30zone.net/e30zonewiki/index.php/ECU
Check your ECU part number here:
http://www.e30zone.net/e30zonewiki/index.php/ECU
'89 325i Touring | Touring Resto Thread | In-Dash Screen install
-
mrLEE30
- E30 Zone Team Member

- Posts: 6589
- Joined: Tue Jan 18, 2005 11:00 pm
- Location: Sweating buckets in Bahrain
Only thing to check is if the ECU is for an auto or manual, mainly as idle speed is different.

-
Brian28
- E30 Zone Squatter

- Posts: 1596
- Joined: Sat Jun 11, 2005 11:00 pm
- Location: Bournemouth
Thanks chaps 
For sale - E30 320i racer project - sold.
-
mrLEE30
- E30 Zone Team Member

- Posts: 6589
- Joined: Tue Jan 18, 2005 11:00 pm
- Location: Sweating buckets in Bahrain
after a re-read it is the chip that controls idle speed anyway, so if you have replaced the chip in an ECU from a Motronic 320 with a chip for a 2.5 it will work fine.

