Panic!!!
Moderator: martauto
-
b12rlw
- E30 Zone Regular

- Posts: 455
- Joined: Tue Feb 24, 2009 11:00 pm
- Location: Irvine Ayrshire
Hey folks, will an auto m20 engine fit straight onto a manual 'box? (using the manual clutch and flywheel arrangement) What i'm getting at is... are the cranks the same at the transmission end? Cheers!
-
eko
- Old timer
- Posts: 11531
- Joined: Sat Feb 05, 2005 11:00 pm
- Location: South Devon
Yes but youll need to fit a thrust bearing into the crank first,cost about a tenner 

-
b12rlw
- E30 Zone Regular

- Posts: 455
- Joined: Tue Feb 24, 2009 11:00 pm
- Location: Irvine Ayrshire
mucho gracia!! the cranks coming out to have the bores honed and the pistons decoked. Is the thrust brg the brg between cyls 5&6?
-
mrLEE30
- E30 Zone Team Member

- Posts: 6589
- Joined: Tue Jan 18, 2005 11:00 pm
- Location: Sweating buckets in Bahrain
no its the bearing between engine and clutch assembly, the autos dont have them so to fit a clutch/man box you must add the bearing.
You also need to consider that the prop shafts are different between the auto, the Getrag 240 manual and the Getrag 260 manual - or at least are different lengths.
you also need to bypass the start inhibitor system as found on the auto box ECU loom
You also need to consider that the prop shafts are different between the auto, the Getrag 240 manual and the Getrag 260 manual - or at least are different lengths.
you also need to bypass the start inhibitor system as found on the auto box ECU loom

-
b12rlw
- E30 Zone Regular

- Posts: 455
- Joined: Tue Feb 24, 2009 11:00 pm
- Location: Irvine Ayrshire
I've got a boosted manual running megasquirt with a knackered head gasket which is donating parts to a nice new auto lump which is being rebuilt ( later low comp model) I've stripped the auto engine yesterday and last night had a thought that the internals are different. That's cool gents, I'll just swap everything over when the old dink gets pulled! Cheers again!!
