misfire at 4k RPM

Need technical Q/A then you're in the right place

Moderator: martauto

User avatar
blingsta
Boost Junkie
Posts: 2930
Joined: Fri Jan 27, 2006 11:00 pm
Location: Enfield

Post Tue Nov 08, 2011 9:13 pm

mateys got a 318i manual on a H plate..
revs upto 4k RPM then starts to misfire? changed the dizzy cap and rotor arm but still the same :?

any ideas guys? runs spot on in all gears upto 4k.

any help to eliminate the problem will be appreciated
User avatar
blingsta
Boost Junkie
Posts: 2930
Joined: Fri Jan 27, 2006 11:00 pm
Location: Enfield

Post Wed Nov 09, 2011 9:48 am

sounds like it hits the rev limiter at 4k ..

anyone?
Grrrmachine
E30 Zone Wiki / Team Member
E30 Zone Wiki / Team Member
Posts: 8043
Joined: Sat Feb 09, 2008 11:00 pm
Location: Warsaw, Poland

Post Wed Nov 09, 2011 10:00 am

Sure it's not the same issue as in the other thread?

http://www.e30zone.net/modules.php?name ... c&t=208872
User avatar
blingsta
Boost Junkie
Posts: 2930
Joined: Fri Jan 27, 2006 11:00 pm
Location: Enfield

Post Wed Nov 09, 2011 10:14 am

im hoping not :(

no mention of misfire.. just not revving past 5k on that thread.. !

would a worn cam cause a misfire at 4k but be spot on before that?

plus the engines not tappy
User avatar
blingsta
Boost Junkie
Posts: 2930
Joined: Fri Jan 27, 2006 11:00 pm
Location: Enfield

Post Wed Nov 09, 2011 1:12 pm

weve just tried another ecu to eliminate that.. still the same :?
could the cat be causing the problem ? plugs, leads, crank sensor?

just feels like its hitting the redline at 4k rpm, runs a tiny bit rough when you let go of the throttle and then starts to run perfect again !! :(
User avatar
blingsta
Boost Junkie
Posts: 2930
Joined: Fri Jan 27, 2006 11:00 pm
Location: Enfield

Post Wed Nov 09, 2011 5:31 pm

We've also tried another AFM.. Still no good.. Gonna try dropping the zaust see if cats blocked
Wocka
E30 Zone Regular
E30 Zone Regular
Posts: 456
Joined: Sat May 17, 2008 11:00 pm
Location: Oxfordshire

Post Wed Nov 09, 2011 5:39 pm

I had this but usually when it was raining. Turned out to be the HT leads.
User avatar
blingsta
Boost Junkie
Posts: 2930
Joined: Fri Jan 27, 2006 11:00 pm
Location: Enfield

Post Wed Nov 09, 2011 5:54 pm

Did it misfire at high revs? Mateys is only doing it at 4k in all gears, rain, shine, hot or cold!! Could be worth checking I suppose
Wocka
E30 Zone Regular
E30 Zone Regular
Posts: 456
Joined: Sat May 17, 2008 11:00 pm
Location: Oxfordshire

Post Wed Nov 09, 2011 6:01 pm

hmm, here's the old thread:
http://www.e30zone.net/modules.php?name ... c&t=149135

Not exactly the same symptoms.
Wocka
E30 Zone Regular
E30 Zone Regular
Posts: 456
Joined: Sat May 17, 2008 11:00 pm
Location: Oxfordshire

Post Wed Nov 09, 2011 6:02 pm

could it be fuel starvation?
User avatar
blingsta
Boost Junkie
Posts: 2930
Joined: Fri Jan 27, 2006 11:00 pm
Location: Enfield

Post Wed Nov 09, 2011 10:40 pm

said he is going to change the fuel filter 2moro and do a fuel pressure check on it.. will update..

if that fails.. will prob try HT leads.. then im sure he'll burn it !!! :D
e301988325i
E30 Zone Addict
E30 Zone Addict
Posts: 3701
Joined: Fri Feb 01, 2008 11:00 pm
Location: Taunton, Somerset

Post Wed Nov 09, 2011 10:42 pm

blingsta wrote:sounds like it hits the rev limiter at 4k ..

anyone?
6cyl coding plug fitted to the instrument cluster? Has it been replaced for any reason recently? What's the MPH in 2nd gear at 4K RPM?
I said:

Can anyone suggest how to test if the boot lights are staying on with the boot shut?

e30topless said:

lock the wife in there
User avatar
blingsta
Boost Junkie
Posts: 2930
Joined: Fri Jan 27, 2006 11:00 pm
Location: Enfield

Post Wed Nov 09, 2011 10:55 pm

Hmmm.... That's one to check then.. As far as I'm aware, the cluster hasn't been changed (in his ownership) will check the MPH in 2nd gear.. What should it be?
User avatar
blingsta
Boost Junkie
Posts: 2930
Joined: Fri Jan 27, 2006 11:00 pm
Location: Enfield

Post Wed Nov 09, 2011 10:58 pm

Could the coding plug do that?
User avatar
blingsta
Boost Junkie
Posts: 2930
Joined: Fri Jan 27, 2006 11:00 pm
Location: Enfield

Post Thu Nov 10, 2011 9:47 am

35mph @ 4k rpm in 2nd gear...

will see what happens with the fuel filter change later..
e301988325i
E30 Zone Addict
E30 Zone Addict
Posts: 3701
Joined: Fri Feb 01, 2008 11:00 pm
Location: Taunton, Somerset

Post Thu Nov 10, 2011 12:29 pm

Ignore my suggestion, but yes a 6cyl coding plug with a 4 cyl engine will read exactly 2/3rds of the actual RPM.
I said:

Can anyone suggest how to test if the boot lights are staying on with the boot shut?

e30topless said:

lock the wife in there
User avatar
blingsta
Boost Junkie
Posts: 2930
Joined: Fri Jan 27, 2006 11:00 pm
Location: Enfield

Post Thu Nov 10, 2011 11:00 pm

ok, so problem continues :cry:

things changed= rotor+dizzy, AFM, ECU, fuel filter

mate carried out a fuel pressure check and all is fine there too..

he's now going to change the plugs, try another crank sensor, HT leads, and finally some different injectors... if all that fails... :shoot1:
Speedtouch
Old Skooler
Old Skooler
Posts: 14130
Joined: Tue Feb 14, 2006 11:00 pm
Location: Canterbury

Post Thu Nov 10, 2011 11:07 pm

Is it possible that the cambelt has jumped a tooth?

I had a 320i that ran fine until Halfords changed the cambelt, then it wouldn't rev beyond about 4K.
///M aurice
ECU Upgrade EPROM Chips, £40 posted within the UK. Note these are not Zone chips.
viewtopic.php?f=6&t=279421
User avatar
blingsta
Boost Junkie
Posts: 2930
Joined: Fri Jan 27, 2006 11:00 pm
Location: Enfield

Post Thu Nov 10, 2011 11:11 pm

i'll mention it to him .. thanks.. did it drive nice and smooth anytime before 4k?
Speedtouch
Old Skooler
Old Skooler
Posts: 14130
Joined: Tue Feb 14, 2006 11:00 pm
Location: Canterbury

Post Thu Nov 10, 2011 11:26 pm

Yes, it started easily and ran fine, but just didn't want to rev.
///M aurice
ECU Upgrade EPROM Chips, £40 posted within the UK. Note these are not Zone chips.
viewtopic.php?f=6&t=279421
User avatar
blingsta
Boost Junkie
Posts: 2930
Joined: Fri Jan 27, 2006 11:00 pm
Location: Enfield

Post Thu Nov 10, 2011 11:30 pm

Lovely, thanks for that, I'll get him to check the timing.
User avatar
blingsta
Boost Junkie
Posts: 2930
Joined: Fri Jan 27, 2006 11:00 pm
Location: Enfield

Post Thu Nov 17, 2011 9:37 am

still scratching our heads on this one guys !! :cry:

a list of whats been done-

new plugs
new dizzy cap and arm
new leads
fuel pressure check
tried another AFM
tried another ECU
checked that the cat isnt blocked


what else can this problem be guys? :x
runs perfect otherwise !!!

any suggestions welcome
popey7676
E30 Zone Regular
E30 Zone Regular
Posts: 301
Joined: Fri Jan 15, 2010 11:00 pm
Location: Devon

Post Thu Nov 17, 2011 9:51 am

I had the same thing on my old 325, but mine was using a bit of coolant, so i changed the head gasket, there was a tiny hole the gasket. After the change i had no more problem!
User avatar
blingsta
Boost Junkie
Posts: 2930
Joined: Fri Jan 27, 2006 11:00 pm
Location: Enfield

Post Thu Nov 17, 2011 10:06 am

Having no coolant issues with this one.

Timing also checked, spot on
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49360
Joined: Mon Jan 10, 2005 11:00 pm

Post Thu Nov 17, 2011 10:18 am

Anyone actually checked the condition of the cam?
User avatar
blingsta
Boost Junkie
Posts: 2930
Joined: Fri Jan 27, 2006 11:00 pm
Location: Enfield

Post Thu Nov 17, 2011 10:28 am

had the rocker cover off yesterday Brian.. cam looked ok from what i saw.

how can you tell if the cam is gone?
User avatar
blingsta
Boost Junkie
Posts: 2930
Joined: Fri Jan 27, 2006 11:00 pm
Location: Enfield

Post Thu Nov 17, 2011 10:29 am

dont think ive mentioned.. when it starts the misfire at 4k rpm.. you can smell fuel until it settles and starts to run good again ?
Wocka
E30 Zone Regular
E30 Zone Regular
Posts: 456
Joined: Sat May 17, 2008 11:00 pm
Location: Oxfordshire

Post Thu Nov 17, 2011 10:41 am

Stab in the dark: Crank sensor?
User avatar
blingsta
Boost Junkie
Posts: 2930
Joined: Fri Jan 27, 2006 11:00 pm
Location: Enfield

Post Thu Nov 17, 2011 10:46 am

im doubting the crank sensor..

thinking more along the lines of injectors?
Wocka
E30 Zone Regular
E30 Zone Regular
Posts: 456
Joined: Sat May 17, 2008 11:00 pm
Location: Oxfordshire

Post Thu Nov 17, 2011 1:55 pm

If you can smell fuel it's either leaking or more likely not firing
User avatar
blingsta
Boost Junkie
Posts: 2930
Joined: Fri Jan 27, 2006 11:00 pm
Location: Enfield

Post Thu Nov 17, 2011 2:25 pm

Just changed the injectors... Still the same
Speedtouch
Old Skooler
Old Skooler
Posts: 14130
Joined: Tue Feb 14, 2006 11:00 pm
Location: Canterbury

Post Thu Nov 17, 2011 4:14 pm

blingsta wrote:still scratching our heads on this one guys !! :cry:

checked that the cat isnt blocked
Would an H-reg 318i have a cat? :? I thought they only came in on the J/K-plate.

Are the spark plugs of the correct type and correctly gapped?

Might be worth measuring the resistance of the HT leads, and maybe running it in the dark and revving it to see if there's any arcing around the ignition components.
///M aurice
ECU Upgrade EPROM Chips, £40 posted within the UK. Note these are not Zone chips.
viewtopic.php?f=6&t=279421
User avatar
greg124
E30 Zone Regular
E30 Zone Regular
Posts: 668
Joined: Tue Apr 03, 2007 11:00 pm
Location: In the pub

Post Thu Nov 17, 2011 4:30 pm

My '91 H reg doesn't have a cat.
That answers one question, but probably doesn't help an awful lot.
Schadenfreude - the German's haven't got a word for that.
User avatar
blingsta
Boost Junkie
Posts: 2930
Joined: Fri Jan 27, 2006 11:00 pm
Location: Enfield

Post Thu Nov 17, 2011 5:57 pm

well this ones definately a 91 H and has definately got a cat ...

but yes .. the spark plugs have just been changed and are of the correct type..

were doubting the camshaft as the engine is not tappety at all.. The HT leads looked fine in appearence with no obvious cracks etc.. but i suppose so much has been changed and done that just revving it in the dark isnt gonna hurt...

anything else guys?
Speedtouch
Old Skooler
Old Skooler
Posts: 14130
Joined: Tue Feb 14, 2006 11:00 pm
Location: Canterbury

Post Fri Nov 18, 2011 3:11 pm

Engine earth strap secure? Tried cleaning the idle control valve (ICV) and TPS?

Try disconnecting the battery or ECU and leaving for an hour to reset it, reconnect and leave to idle for 10 minutes, switch off, then go for a drive.
///M aurice
ECU Upgrade EPROM Chips, £40 posted within the UK. Note these are not Zone chips.
viewtopic.php?f=6&t=279421