Need technical Q/A then you're in the right place
Moderator: martauto
-
blingsta
- Boost Junkie
- Posts: 2930
- Joined: Fri Jan 27, 2006 11:00 pm
- Location: Enfield
Post
Tue Nov 08, 2011 9:13 pm
mateys got a 318i manual on a H plate..
revs upto 4k RPM then starts to misfire? changed the dizzy cap and rotor arm but still the same
any ideas guys? runs spot on in all gears upto 4k.
any help to eliminate the problem will be appreciated
-
blingsta
- Boost Junkie
- Posts: 2930
- Joined: Fri Jan 27, 2006 11:00 pm
- Location: Enfield
Post
Wed Nov 09, 2011 9:48 am
sounds like it hits the rev limiter at 4k ..
anyone?
-
Grrrmachine
- E30 Zone Wiki / Team Member

- Posts: 8043
- Joined: Sat Feb 09, 2008 11:00 pm
- Location: Warsaw, Poland
-
blingsta
- Boost Junkie
- Posts: 2930
- Joined: Fri Jan 27, 2006 11:00 pm
- Location: Enfield
Post
Wed Nov 09, 2011 10:14 am
im hoping not
no mention of misfire.. just not revving past 5k on that thread.. !
would a worn cam cause a misfire at 4k but be spot on before that?
plus the engines not tappy
-
blingsta
- Boost Junkie
- Posts: 2930
- Joined: Fri Jan 27, 2006 11:00 pm
- Location: Enfield
Post
Wed Nov 09, 2011 1:12 pm
weve just tried another ecu to eliminate that.. still the same
could the cat be causing the problem ? plugs, leads, crank sensor?
just feels like its hitting the redline at 4k rpm, runs a tiny bit rough when you let go of the throttle and then starts to run perfect again !!

-
blingsta
- Boost Junkie
- Posts: 2930
- Joined: Fri Jan 27, 2006 11:00 pm
- Location: Enfield
Post
Wed Nov 09, 2011 5:31 pm
We've also tried another AFM.. Still no good.. Gonna try dropping the zaust see if cats blocked
-
Wocka
- E30 Zone Regular

- Posts: 456
- Joined: Sat May 17, 2008 11:00 pm
- Location: Oxfordshire
Post
Wed Nov 09, 2011 5:39 pm
I had this but usually when it was raining. Turned out to be the HT leads.
-
blingsta
- Boost Junkie
- Posts: 2930
- Joined: Fri Jan 27, 2006 11:00 pm
- Location: Enfield
Post
Wed Nov 09, 2011 5:54 pm
Did it misfire at high revs? Mateys is only doing it at 4k in all gears, rain, shine, hot or cold!! Could be worth checking I suppose
-
Wocka
- E30 Zone Regular

- Posts: 456
- Joined: Sat May 17, 2008 11:00 pm
- Location: Oxfordshire
-
Wocka
- E30 Zone Regular

- Posts: 456
- Joined: Sat May 17, 2008 11:00 pm
- Location: Oxfordshire
Post
Wed Nov 09, 2011 6:02 pm
could it be fuel starvation?
-
blingsta
- Boost Junkie
- Posts: 2930
- Joined: Fri Jan 27, 2006 11:00 pm
- Location: Enfield
Post
Wed Nov 09, 2011 10:40 pm
said he is going to change the fuel filter 2moro and do a fuel pressure check on it.. will update..
if that fails.. will prob try HT leads.. then im sure he'll burn it !!!

-
e301988325i
- E30 Zone Addict

- Posts: 3701
- Joined: Fri Feb 01, 2008 11:00 pm
- Location: Taunton, Somerset
Post
Wed Nov 09, 2011 10:42 pm
blingsta wrote:sounds like it hits the rev limiter at 4k ..
anyone?
6cyl coding plug fitted to the instrument cluster? Has it been replaced for any reason recently? What's the MPH in 2nd gear at 4K RPM?
I said:
Can anyone suggest how to test if the boot lights are staying on with the boot shut?
e30topless said:
lock the wife in there
-
blingsta
- Boost Junkie
- Posts: 2930
- Joined: Fri Jan 27, 2006 11:00 pm
- Location: Enfield
Post
Wed Nov 09, 2011 10:55 pm
Hmmm.... That's one to check then.. As far as I'm aware, the cluster hasn't been changed (in his ownership) will check the MPH in 2nd gear.. What should it be?
-
blingsta
- Boost Junkie
- Posts: 2930
- Joined: Fri Jan 27, 2006 11:00 pm
- Location: Enfield
Post
Wed Nov 09, 2011 10:58 pm
Could the coding plug do that?
-
blingsta
- Boost Junkie
- Posts: 2930
- Joined: Fri Jan 27, 2006 11:00 pm
- Location: Enfield
Post
Thu Nov 10, 2011 9:47 am
35mph @ 4k rpm in 2nd gear...
will see what happens with the fuel filter change later..
-
e301988325i
- E30 Zone Addict

- Posts: 3701
- Joined: Fri Feb 01, 2008 11:00 pm
- Location: Taunton, Somerset
Post
Thu Nov 10, 2011 12:29 pm
Ignore my suggestion, but yes a 6cyl coding plug with a 4 cyl engine will read exactly 2/3rds of the actual RPM.
I said:
Can anyone suggest how to test if the boot lights are staying on with the boot shut?
e30topless said:
lock the wife in there
-
blingsta
- Boost Junkie
- Posts: 2930
- Joined: Fri Jan 27, 2006 11:00 pm
- Location: Enfield
Post
Thu Nov 10, 2011 11:00 pm
ok, so problem continues
things changed= rotor+dizzy, AFM, ECU, fuel filter
mate carried out a fuel pressure check and all is fine there too..
he's now going to change the plugs, try another crank sensor, HT leads, and finally some different injectors... if all that fails...

-
Speedtouch
- Old Skooler

- Posts: 14130
- Joined: Tue Feb 14, 2006 11:00 pm
- Location: Canterbury
Post
Thu Nov 10, 2011 11:07 pm
Is it possible that the cambelt has jumped a tooth?
I had a 320i that ran fine until Halfords changed the cambelt, then it wouldn't rev beyond about 4K.
-
blingsta
- Boost Junkie
- Posts: 2930
- Joined: Fri Jan 27, 2006 11:00 pm
- Location: Enfield
Post
Thu Nov 10, 2011 11:11 pm
i'll mention it to him .. thanks.. did it drive nice and smooth anytime before 4k?
-
Speedtouch
- Old Skooler

- Posts: 14130
- Joined: Tue Feb 14, 2006 11:00 pm
- Location: Canterbury
Post
Thu Nov 10, 2011 11:26 pm
Yes, it started easily and ran fine, but just didn't want to rev.
-
blingsta
- Boost Junkie
- Posts: 2930
- Joined: Fri Jan 27, 2006 11:00 pm
- Location: Enfield
Post
Thu Nov 10, 2011 11:30 pm
Lovely, thanks for that, I'll get him to check the timing.
-
blingsta
- Boost Junkie
- Posts: 2930
- Joined: Fri Jan 27, 2006 11:00 pm
- Location: Enfield
Post
Thu Nov 17, 2011 9:37 am
still scratching our heads on this one guys !!
a list of whats been done-
new plugs
new dizzy cap and arm
new leads
fuel pressure check
tried another AFM
tried another ECU
checked that the cat isnt blocked
what else can this problem be guys?
runs perfect otherwise !!!
any suggestions welcome
-
popey7676
- E30 Zone Regular

- Posts: 301
- Joined: Fri Jan 15, 2010 11:00 pm
- Location: Devon
Post
Thu Nov 17, 2011 9:51 am
I had the same thing on my old 325, but mine was using a bit of coolant, so i changed the head gasket, there was a tiny hole the gasket. After the change i had no more problem!
-
blingsta
- Boost Junkie
- Posts: 2930
- Joined: Fri Jan 27, 2006 11:00 pm
- Location: Enfield
Post
Thu Nov 17, 2011 10:06 am
Having no coolant issues with this one.
Timing also checked, spot on
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Post
Thu Nov 17, 2011 10:18 am
Anyone actually checked the condition of the cam?
-
blingsta
- Boost Junkie
- Posts: 2930
- Joined: Fri Jan 27, 2006 11:00 pm
- Location: Enfield
Post
Thu Nov 17, 2011 10:28 am
had the rocker cover off yesterday Brian.. cam looked ok from what i saw.
how can you tell if the cam is gone?
-
blingsta
- Boost Junkie
- Posts: 2930
- Joined: Fri Jan 27, 2006 11:00 pm
- Location: Enfield
Post
Thu Nov 17, 2011 10:29 am
dont think ive mentioned.. when it starts the misfire at 4k rpm.. you can smell fuel until it settles and starts to run good again ?
-
Wocka
- E30 Zone Regular

- Posts: 456
- Joined: Sat May 17, 2008 11:00 pm
- Location: Oxfordshire
Post
Thu Nov 17, 2011 10:41 am
Stab in the dark: Crank sensor?
-
blingsta
- Boost Junkie
- Posts: 2930
- Joined: Fri Jan 27, 2006 11:00 pm
- Location: Enfield
Post
Thu Nov 17, 2011 10:46 am
im doubting the crank sensor..
thinking more along the lines of injectors?
-
Wocka
- E30 Zone Regular

- Posts: 456
- Joined: Sat May 17, 2008 11:00 pm
- Location: Oxfordshire
Post
Thu Nov 17, 2011 1:55 pm
If you can smell fuel it's either leaking or more likely not firing
-
blingsta
- Boost Junkie
- Posts: 2930
- Joined: Fri Jan 27, 2006 11:00 pm
- Location: Enfield
Post
Thu Nov 17, 2011 2:25 pm
Just changed the injectors... Still the same
-
Speedtouch
- Old Skooler

- Posts: 14130
- Joined: Tue Feb 14, 2006 11:00 pm
- Location: Canterbury
Post
Thu Nov 17, 2011 4:14 pm
blingsta wrote:still scratching our heads on this one guys !!
checked that the cat isnt blocked
Would an H-reg 318i have a cat?

I thought they only came in on the J/K-plate.
Are the spark plugs of the correct type and correctly gapped?
Might be worth measuring the resistance of the HT leads, and maybe running it in the dark and revving it to see if there's any arcing around the ignition components.
-
greg124
- E30 Zone Regular

- Posts: 668
- Joined: Tue Apr 03, 2007 11:00 pm
- Location: In the pub
Post
Thu Nov 17, 2011 4:30 pm
My '91 H reg doesn't have a cat.
That answers one question, but probably doesn't help an awful lot.
Schadenfreude - the German's haven't got a word for that.
-
blingsta
- Boost Junkie
- Posts: 2930
- Joined: Fri Jan 27, 2006 11:00 pm
- Location: Enfield
Post
Thu Nov 17, 2011 5:57 pm
well this ones definately a 91 H and has definately got a cat ...
but yes .. the spark plugs have just been changed and are of the correct type..
were doubting the camshaft as the engine is not tappety at all.. The HT leads looked fine in appearence with no obvious cracks etc.. but i suppose so much has been changed and done that just revving it in the dark isnt gonna hurt...
anything else guys?
-
Speedtouch
- Old Skooler

- Posts: 14130
- Joined: Tue Feb 14, 2006 11:00 pm
- Location: Canterbury
Post
Fri Nov 18, 2011 3:11 pm
Engine earth strap secure? Tried cleaning the idle control valve (ICV) and TPS?
Try disconnecting the battery or ECU and leaving for an hour to reset it, reconnect and leave to idle for 10 minutes, switch off, then go for a drive.