my 318i auto cab only revs to 4500rpm when i put my foot down, stays at those revs, then changes gear after 2-3 seconds
I've been told a mixture of things like the distributor cap,rotor arm, leads and plugs need changing,
does this problem sound familiar to anyone and would you know what it'd be?
only revving to 4500 rpm?
Moderator: martauto
-
Jhonno
- Homo Hair
- Posts: 20362
- Joined: Mon Jan 10, 2005 11:00 pm
- Location: FLAT, FLAT, FLAT!!
Tried holding it in gear?
-
greg124
- E30 Zone Regular

- Posts: 668
- Joined: Tue Apr 03, 2007 11:00 pm
- Location: In the pub
worn camshaft, possibly?
Schadenfreude - the German's haven't got a word for that.
-
pacerpete
- E30 Zone Team Member

- Posts: 18165
- Joined: Sun Jan 23, 2005 11:00 pm
- Location: Iver heath. South bucks.
Thisgreg124 wrote:worn camshaft, possibly?
Worn camgear / lifters is the most common reason for an elderly M40 to not pull to the redline . They don't neccessarily need to sound dire to suffer from this ailment either .
Last edited by pacerpete on Mon Nov 07, 2011 7:49 pm, edited 1 time in total.
-
e30topless
- E30 Zone Team Member

- Posts: 13595
- Joined: Wed Aug 23, 2006 11:00 pm
- Location: surrounded by scrap
toblerone cam syndrome, 
-
redcar
- E30 Zone Squatter

- Posts: 1610
- Joined: Wed Jul 20, 2011 11:00 pm
- Location: Hertfordshire
Mine did this, doesn't rev past 5000, then when I shifted, it still spluttered for a few seconds.
Was advised that the camshaft was gone. A chap came up with a funny saying for the noise it made on idle. Tappety it was! Good luck
Was advised that the camshaft was gone. A chap came up with a funny saying for the noise it made on idle. Tappety it was! Good luck
-
Alex
- Married to the E30 Zone

- Posts: 22665
- Joined: Fri Feb 11, 2005 11:00 pm
- Location: Johannesburg, South Africa
first off all i would eliminate the autobox with some fresh oil and a new filter.
however if your engine sounds tappety then its 99% going to be a wanker cam
try holding it in gear, my 318i auto changes at 5000rpm but if you hold it in gear goes to revlimit easily. ive yet to change oil and filter.
however if your engine sounds tappety then its 99% going to be a wanker cam
try holding it in gear, my 318i auto changes at 5000rpm but if you hold it in gear goes to revlimit easily. ive yet to change oil and filter.
-
domkolo
- E30 Zone Regular

- Posts: 437
- Joined: Sat Nov 27, 2010 11:00 pm
thanks for the advice guys, hopefully pacerpete will be able to make good sense of what the problem is this weekend!
it changes fine when im just plodding along but when i hold it in gear it sits on 4500 and splutters for 2-3 seconds before changing up a gear, then it feels like it's down on power,
I had a chap look at it and the weekend when i had a few neccessary bits done. he said the auto box was fine so i guess it all adds up to be the cam shaft like you guys have kindly advised!
nice one!
it changes fine when im just plodding along but when i hold it in gear it sits on 4500 and splutters for 2-3 seconds before changing up a gear, then it feels like it's down on power,
I had a chap look at it and the weekend when i had a few neccessary bits done. he said the auto box was fine so i guess it all adds up to be the cam shaft like you guys have kindly advised!
nice one!
-
AlpineAde
- E30 Zone Team Member

- Posts: 3829
- Joined: Sun Feb 25, 2007 11:00 pm
- Location: Melbourne, Australia
How's your coil, OP?
-
Grrrmachine
- E30 Zone Wiki / Team Member

- Posts: 8043
- Joined: Sat Feb 09, 2008 11:00 pm
- Location: Warsaw, Poland
"skeleton wanking into a dustbin" was the phrase used to describe a knackered cam 
'89 325i Touring | Touring Resto Thread | In-Dash Screen install
-
blingsta
- Boost Junkie
- Posts: 2930
- Joined: Fri Jan 27, 2006 11:00 pm
- Location: Enfield
is this sorted? ive just started a thread for a mates 318i revving to 4k then misfiring ? its not a auto though... ?? well confused..


