M52 rod bolts, tightening spec?
Moderator: martauto
-
Simon13
- The longest resto in the world !
- Posts: 22697
- Joined: Mon Jan 10, 2005 11:00 pm
- Location: Camberley, Surrey don't u know
Are these like M20 ones where its 20Nm and then 70 degrees?
-
maggspower
- Turbo Farmer Tractor Driver
- Posts: 2376
- Joined: Wed Oct 12, 2005 11:00 pm
- Location: Nowhere near South Wales, ok butt
I thought that these were the same as m20 ones, but no. They do spread across quite a bit of the range though
http://www.realoem.com/bmw/partxref.do?part=11247589671
For the 4 cyl e30 using these bolts it says 55nm, and no further angle, according to my bentley book. I would wait for confirmation of this though.
http://www.realoem.com/bmw/partxref.do?part=11247589671
For the 4 cyl e30 using these bolts it says 55nm, and no further angle, according to my bentley book. I would wait for confirmation of this though.
-
Andyboy
- Alpina Colada
- Posts: 12577
- Joined: Mon Sep 11, 2006 11:00 pm
- Location: Notts
According to BMW, 20nm and 70 degrees. Haynes backs this up as well. It's the same on the M40 and M43 4 cyl motors too.Simon13 wrote:Are these like M20 ones where its 20Nm and then 70 degrees?
-
Simon13
- The longest resto in the world !
- Posts: 22697
- Joined: Mon Jan 10, 2005 11:00 pm
- Location: Camberley, Surrey don't u know
I hope so i've just done them up on my rebuild like this and then thought poo didn't check this before.....
i can change if its not correct but thought i'd ask the greater collective!
i can change if its not correct but thought i'd ask the greater collective!
-
maggspower
- Turbo Farmer Tractor Driver
- Posts: 2376
- Joined: Wed Oct 12, 2005 11:00 pm
- Location: Nowhere near South Wales, ok butt
Yep andy is right, check page 28 of the torque tightening sticky in the tech section 
-
Andyboy
- Alpina Colada
- Posts: 12577
- Joined: Mon Sep 11, 2006 11:00 pm
- Location: Notts
Thought you'd have installed some ARP rightness Si. Nothing wrong with the BMW bolts though.
-
DanThe
- E30 Zone Team Member

- Posts: 28649
- Joined: Sat Sep 10, 2005 11:00 pm
- Location: Staffs
An M20 is never going to rev enough to warrant ARP! 
-
Simon13
- The longest resto in the world !
- Posts: 22697
- Joined: Mon Jan 10, 2005 11:00 pm
- Location: Camberley, Surrey don't u know
Now this is true!
