M52 rod bolts, tightening spec?

Need technical Q/A then you're in the right place

Moderator: martauto

Simon13
The longest resto in the world !
Posts: 22697
Joined: Mon Jan 10, 2005 11:00 pm
Location: Camberley, Surrey don't u know

Post Mon Oct 24, 2011 10:39 pm

Are these like M20 ones where its 20Nm and then 70 degrees?
maggspower
Turbo Farmer Tractor Driver
Posts: 2376
Joined: Wed Oct 12, 2005 11:00 pm
Location: Nowhere near South Wales, ok butt

Post Mon Oct 24, 2011 10:57 pm

I thought that these were the same as m20 ones, but no. They do spread across quite a bit of the range though :mad:

http://www.realoem.com/bmw/partxref.do?part=11247589671

For the 4 cyl e30 using these bolts it says 55nm, and no further angle, according to my bentley book. I would wait for confirmation of this though.
Andyboy
Alpina Colada
Posts: 12577
Joined: Mon Sep 11, 2006 11:00 pm
Location: Notts

Post Mon Oct 24, 2011 11:03 pm

Simon13 wrote:Are these like M20 ones where its 20Nm and then 70 degrees?
According to BMW, 20nm and 70 degrees. Haynes backs this up as well. It's the same on the M40 and M43 4 cyl motors too.
Simon13
The longest resto in the world !
Posts: 22697
Joined: Mon Jan 10, 2005 11:00 pm
Location: Camberley, Surrey don't u know

Post Mon Oct 24, 2011 11:10 pm

I hope so i've just done them up on my rebuild like this and then thought poo didn't check this before.....

i can change if its not correct but thought i'd ask the greater collective!
maggspower
Turbo Farmer Tractor Driver
Posts: 2376
Joined: Wed Oct 12, 2005 11:00 pm
Location: Nowhere near South Wales, ok butt

Post Mon Oct 24, 2011 11:29 pm

Yep andy is right, check page 28 of the torque tightening sticky in the tech section :)
Andyboy
Alpina Colada
Posts: 12577
Joined: Mon Sep 11, 2006 11:00 pm
Location: Notts

Post Tue Oct 25, 2011 9:07 am

Thought you'd have installed some ARP rightness Si. Nothing wrong with the BMW bolts though.
DanThe
E30 Zone Team Member
E30 Zone Team Member
Posts: 28649
Joined: Sat Sep 10, 2005 11:00 pm
Location: Staffs

Post Tue Oct 25, 2011 5:52 pm

An M20 is never going to rev enough to warrant ARP! :D
Simon13
The longest resto in the world !
Posts: 22697
Joined: Mon Jan 10, 2005 11:00 pm
Location: Camberley, Surrey don't u know

Post Tue Oct 25, 2011 7:57 pm

Now this is true!