anyway after disconnecting everything ready to remove i noticed the wires at the c101 plug (car end of the loom) was all taped up, upon removing the tape i found this!!!

all wires were connected with blocks and a few cut hanging loose! looking at it i found the brown wire on pin 20 is cut, but i read a page by brian saying that should be done... that correct?
also there was a loose black,
a loose red/yellow
a loose yellow/white
and a loose green/purple although the green/purple has a matching cut wire on the plug!
there was a wire running from the red/yellow to the coil and also the black was the same, think this was to do with dodgy home made alarm system,
also in the pic you can see 2 red wires coming from a block connecting the purple/red wire. the thicker red runs to the ignition cowling, the other goes into the fuse box, ould this be for same dodgy alarm or something else, think the thin one maybe direct to headunit!
bare with me lol
now am i to believe that i can attach the red/yellow to the remains of the brown to make abs work (brian?)
basically to cut a long story short i would like to know what every pin on the c101 plug for and also all wire colours and what they are for ie:
pin 1 - colour - what its for
pin 2 - colour - what its for
etc etc
or a good link with all this info?
so i can do a better neater job
thanks
adam











