1.
Black stuff? -I've just cut and ground out the entire outer rear wheel housing section on my M-tech 2 325i Sport (1988). This is the inner section that butts up against the inside of the off-side rear wing. My question is what exactly was the black paste I found smeared liberally around the petrol flap hole between the rear wing and the wheel housing? I assume it was bitumen of some sort to stop the vibration between these two sections because they sit so close together when assembled? Rather than smear something equally messy there upon reassembly I'm tempted to cut out some anti-vibration/sound deadening material to stop any potential vibrations. Has anyone else done this or should I just reapply the black paste?
2.
Post-Welding Primer. Once I have welded in the new housing and patch-welded a couple of other rust holes, I want to spray the welded arears with some primer that protects the weld and stops new rust appearing there. I've heared that red oxide primer is porus and doesn't stop the rusting process on it's own. What is the best stuff to use? Perhaps someone also knows about applying seam paste, which I guess is applied to the weld or a panel join area after the primer has dried.
Your thoughts?
