Temperature gauge doing strange things.

Need technical Q/A then you're in the right place

Moderator: martauto

User avatar
ah
E30 Zone Addict
E30 Zone Addict
Posts: 2518
Joined: Mon Mar 10, 2008 11:00 pm
Location: surrey

Post Sun Sep 25, 2011 6:20 pm

Before I start I have put a new a new sender unit on it about six months ago.When I turn the ignition on the needle sometimes cranks over to left of centre,but then it just touches the first line.Today I noticed the needle just touches the blue area,whats going on?
Image
Born on the 23 April 1990 320i Alpinweiss ll kabriolett! (SOLD BUT NOT FORGOTTEN !) :cry:
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49360
Joined: Mon Jan 10, 2005 11:00 pm

Post Sun Sep 25, 2011 9:17 pm

Tightened the small brass nut on the back of the cluster?
User avatar
ah
E30 Zone Addict
E30 Zone Addict
Posts: 2518
Joined: Mon Mar 10, 2008 11:00 pm
Location: surrey

Post Mon Sep 26, 2011 6:28 pm

Cheers Brian,do the nuts have to be brass as one was missing and Ive replaced it, but it was a steel nut.would this cause any problems.
Image
Born on the 23 April 1990 320i Alpinweiss ll kabriolett! (SOLD BUT NOT FORGOTTEN !) :cry:
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49360
Joined: Mon Jan 10, 2005 11:00 pm

Post Tue Sep 27, 2011 9:36 am

Better than none. Should be OK unless it corrodes, and if you get corrosion in this area, then a temp. gauge problem is the least of your worries!