swapping injectors?
Moderator: martauto
-
Cloggy Saint
- Old Skooler

- Posts: 8027
- Joined: Sun Jan 09, 2005 11:00 pm
- Location: zummerzet
-
Jim320i
- E30 Zone News / COTM Team

- Posts: 10627
- Joined: Sun Oct 25, 2009 11:00 pm
- Location: Leicestershire
I would remove the rail first as you get more 'angle' when pulling them out, where as when they are still attached to the rail, you have limited movement
One of them jobs I keep putting off.
One of them jobs I keep putting off.
-
e30topless
- E30 Zone Team Member

- Posts: 13595
- Joined: Wed Aug 23, 2006 11:00 pm
- Location: surrounded by scrap
which ever way you choose just try to pull them out straight you don't want to leave a pintle cap behind
it makes the job easier if you spray wd40 towards the base of the injector where it goes into the inlet to lube the o ring that holds them in
it makes the job easier if you spray wd40 towards the base of the injector where it goes into the inlet to lube the o ring that holds them in
-
daimlerman
- **BANNED**
- Posts: 15968
- Joined: Mon Feb 27, 2006 11:00 pm
- Location: Grumpy Old Man
When you lift the fuel rail out,you will find that some injectors will come with it,and some will be left behind.
Fiddle the fuel rail out toward the front of the engine,it's easier if you dis-connect the temp sensors and remove the injector sub-loom first,take note of the way it threads through the manifold to C191.
The support bracket from the rocker cover to the inlet will need removing so that you can see what you are about,and the fuel rail is held by four 10mm bolts.
M20 injectors are a proper PITA to remove,M50 are a doddle by comparision!
Fiddle the fuel rail out toward the front of the engine,it's easier if you dis-connect the temp sensors and remove the injector sub-loom first,take note of the way it threads through the manifold to C191.
The support bracket from the rocker cover to the inlet will need removing so that you can see what you are about,and the fuel rail is held by four 10mm bolts.
M20 injectors are a proper PITA to remove,M50 are a doddle by comparision!
Youth is wasted on the young.
-
Cloggy Saint
- Old Skooler

- Posts: 8027
- Joined: Sun Jan 09, 2005 11:00 pm
- Location: zummerzet
-
E30Gheko
- E30 Zone Addict

- Posts: 3789
- Joined: Sun Sep 28, 2008 11:00 pm
- Location: Wirral
I've done this a few times on M20's and always managed to remove the injectors still attached to the fuel rail. Once removed it's a doddle to swap them and then refit the whole thing.

