Speedo signal - what happens to it?

Need technical Q/A then you're in the right place

Moderator: martauto

User avatar
Mikey_Boy
E30 Zone Regular
E30 Zone Regular
Posts: 996
Joined: Sun Mar 16, 2008 11:00 pm
Location: Cheshire - trying to avoid the bling!

Post Sat Sep 24, 2011 10:05 am

Folks,

Hopefully someone out there knows! I have just replaced my dash with Stack gauges - the thread is here:

http://www.e30zone.net/modules.php?name ... c&t=206285

After calibration, the speedo waggles around quite a lot so wondering how the signal from the diff sensor is cleaned up? DanThe has pointed me in this direction, but this is where I need some help please!

Any pointers on how the diff signal to the speedo is cleaned up would be really helpful...

Thanks all!
:thumb:
Mike
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49360
Joined: Mon Jan 10, 2005 11:00 pm

Post Sat Sep 24, 2011 11:35 am

The signal from the diff. is a simple square wave that needs a voltage applied to it to get this signal. It produces no voltage of its own.
All the processing (integration) is done on the speedo daughter board, where the resulting signal is fed to the speedo and odometer motors directly, and the signal is also fed to the SI board for distribution to the econometer circuits, the SI computer, OBC, engine ECU, cruise control, and radio volume control.
User avatar
Mikey_Boy
E30 Zone Regular
E30 Zone Regular
Posts: 996
Joined: Sun Mar 16, 2008 11:00 pm
Location: Cheshire - trying to avoid the bling!

Post Sat Sep 24, 2011 12:39 pm

Ah balls - I thought it might be more complex than I imagined... 8O Just to let you know - the Stack speedo has the following options for a signal:

Hall effect sender - 3 wire (5 to 16V)
Sine wave generator - 2 wire (1.4 VAC min)
5V Square wave (CMOS)

Being perfectly honest, I didn't know if the diff sensor was a sine wave or square wave so trying to make life easy for me, I wired pin B12 from the white connector to the Stack speedo signal and took pin B8 to ground. Odd thing is the Stack speedo recognises there are pulses so am I right in assuming that it's seeing the square wave and thinking it's a sine wave?

I am going to drop Stack an email and see what they have to sort this - also Geoffbob has posted in my original thread so I shall PM him and see what solutions he has up his sleeve, but please, if you do have any ideas, I would be most grateful! :D

Thanks for the education Brian - I didn't realise the BMW dash did so much! :thumb:

Cheers,
:thumb:
Mike
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49360
Joined: Mon Jan 10, 2005 11:00 pm

Post Sat Sep 24, 2011 2:40 pm

Five volt supply, through a resistor to the diff sensor, earth the other side of the diff sensor.
This will give you a five volt square wave at the junction of the sensor and the resistor.
User avatar
Mikey_Boy
E30 Zone Regular
E30 Zone Regular
Posts: 996
Joined: Sun Mar 16, 2008 11:00 pm
Location: Cheshire - trying to avoid the bling!

Post Sun Sep 25, 2011 10:55 am

Great stuff - thanks Brian! :thumb:

Geoff has suggested something very similar... winkeye

Cheers,
Mike