Here you can see what I have to play with. about 3mm poking out.

It's a little out of focus but what could I do with this.

Moderator: martauto






It truly is, especially on a part that is quite important. So can the bit that I have f***** up not removable and cannot be replaced? The problem is, I can't move the car and I am strapped for cash also I don't know any places on the Isle of Man.turkeysneck wrote:That's a recipe for disaster , I'd find an engineering firm who has a spark eroder. At the very worst they will drill and tap it or helicoil it. If you attempt it yourself you'll ruin it.



Would the screwdriver not just slip out? as 2mm is not a lot to play with :/kyland wrote:You could try using a hacksaw to cut a slot in the end of the broken bolt and then turn it out with a screwdriver perhaps?

I'll definitely have to try that, thanks!clipper wrote:I snapped a sump bolt which only had about 2-mmm protruding, so I selected a Torx socket which wouldn't quite slide over the exposed part of the bolt, tapped iton with a light hammer, the torx cket gripped prety well even with only a few mm to go on due to the way the thread deformed evenly and allowed me to wind out the bolt.
Might work for you too.


Le Mans Classic 2006
It is a good size but the bolt has ended up like this: > (Sorry best way to describe it.) So the mole grips just slid off without getting and purchase on it. I have some mini files to file it down but it does not work. Would heat help the problem here?powelly wrote:Unless it's seized in that should unwind easily, if it's tight then you must have bottomed the bolt out somehow and that broken bit is still under load, to be fair that actually looks to me like a reasonable amount to get a purchase on with some mole grips, use some plus gas to help and a as Si said a heat gun might help a bit, certainly won't get eneough heat in to damage anything.



Steve. It's nowt to do with bottoming out mate. It's a pre placed stud that the housing slides over, not a long bolt. They seize due to minute coolant weeps, the reaction between the alloy housing and the steel bolt and the vastly different heat ranges.powelly wrote:Unless it's seized in that should unwind easily, if it's tight then you must have bottomed the bolt out somehow and that broken bit is still under load, to be fair that actually looks to me like a reasonable amount to get a purchase on with some mole grips, use some plus gas to help and a as Si said a heat gun might help a bit, certainly won't get eneough heat in to damage anything.