guys how hard is it to do the rear oil seal on the getrag m20 gearbox ?
cheers
rear oil seal gearbox m20
Moderator: martauto
-
ross2009
- E30 Zone Addict

- Posts: 2762
- Joined: Mon Nov 19, 2007 11:00 pm
- Location: In my beemer MAN !!!! st neots CAMBS
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Not particularly difficult, but two points to note:
1) The splines need sealant applied to them when you reassemble, or oil will leak along them, bypassing the seal.
2) Most rear gearbox seal 'leaks' are actually leaks from the small selector shaft seal directly above it.
1) The splines need sealant applied to them when you reassemble, or oil will leak along them, bypassing the seal.
2) Most rear gearbox seal 'leaks' are actually leaks from the small selector shaft seal directly above it.
-
ross2009
- E30 Zone Addict

- Posts: 2762
- Joined: Mon Nov 19, 2007 11:00 pm
- Location: In my beemer MAN !!!! st neots CAMBS
well bugger me Brian your right ive already got it up just went and had a look and in fact it I'd the selector shaft how easy are they to do?
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Access can be the main problem. Removing the rear crossmember and letting the back of the box drop a little helps.
Remove the linkage, slide the spring clip around the joint on the end of the selector shaft out of the way, push the pin out and remove the joint. Hook the seal out with a small screwdriver.
Remove the linkage, slide the spring clip around the joint on the end of the selector shaft out of the way, push the pin out and remove the joint. Hook the seal out with a small screwdriver.
-
ross2009
- E30 Zone Addict

- Posts: 2762
- Joined: Mon Nov 19, 2007 11:00 pm
- Location: In my beemer MAN !!!! st neots CAMBS
it's ok I've already done it lol I've only dropped the prop and took the linkage of job done but now where am I gonna get a new oil seal today 

