Done a bit of searching on here last night but no conclusive answer apart from this.
From what ive read on other forums you get the car up to temp, pull all the plugs and squirt about 20ml into each cylinder, leave soak for approx 15 minutes. Rags over the plug holes and turn over the engine till most of it is out, plugs back in, fire it up and go for a drive to clear the rest.Andy335Touring wrote:When i had my old E34 535 the local RR found that the vac line to the fuel reg had perished where it connects under the manifold where you can't see it and the compression figures were a little low due to the piston rings being gummed up due to the short trips i was using the car for, they poured some redex down the spark plug holes and let it soak. The before and after compression figures showed that they had made a 15-20PSI increase on all the cylinders.
So my question is, is this advisable?



