Redex directly down the cylinders.

Need technical Q/A then you're in the right place

Moderator: martauto

leeparkes
Married to the E30 Zone
Married to the E30 Zone
Posts: 9535
Joined: Thu Jan 03, 2008 11:00 pm
Location: Black country

Post Tue Sep 13, 2011 5:50 pm

Spoke to a guy over the weekend who said he used to do this to perk up an old engine.
Done a bit of searching on here last night but no conclusive answer apart from this.
Andy335Touring wrote:When i had my old E34 535 the local RR found that the vac line to the fuel reg had perished where it connects under the manifold where you can't see it and the compression figures were a little low due to the piston rings being gummed up due to the short trips i was using the car for, they poured some redex down the spark plug holes and let it soak. The before and after compression figures showed that they had made a 15-20PSI increase on all the cylinders.
From what ive read on other forums you get the car up to temp, pull all the plugs and squirt about 20ml into each cylinder, leave soak for approx 15 minutes. Rags over the plug holes and turn over the engine till most of it is out, plugs back in, fire it up and go for a drive to clear the rest.

So my question is, is this advisable? :)
Cypriotgeeza wrote:I done both my mates in my old 318is
felt so proud,even tried it with a E30 325i and got put in my place.. :o:
Wocka
E30 Zone Regular
E30 Zone Regular
Posts: 456
Joined: Sat May 17, 2008 11:00 pm
Location: Oxfordshire

Post Tue Sep 13, 2011 6:23 pm

I cant see that doing anything other than smoking out your road.

And why would "gummed up" piston rings lower compression? ppfffft.
asmith88
E30 Zone Addict
E30 Zone Addict
Posts: 2684
Joined: Sat Aug 23, 2008 11:00 pm
Location: Co Down, N.I

Post Tue Sep 13, 2011 9:01 pm

not sure on these, but this makes a good difference on diesel renault engines, for compression
1990 brilliant red 318 is
DHFiS
Old Skooler
Old Skooler
Posts: 2733
Joined: Sat Aug 12, 2006 11:00 pm
Location: cambridge

Post Tue Sep 13, 2011 9:15 pm

Dont waste your money.
Ajsingh
E30 Zone Addict
E30 Zone Addict
Posts: 2378
Joined: Sun Mar 28, 2010 11:00 pm
Location: West Laaaandaan init! / Milton Keynes

Post Tue Sep 13, 2011 10:53 pm

Tried this on a car once, had very low compression. Put slight bit of oil down the bores, left for a while and it fired up... Let it idle for a bit and then re done a compression test. The figures were much much better than before... Took car for a drive and it drove spot on....

iirc it was a y reg honda accord
E30 Crazy!
Wocka
E30 Zone Regular
E30 Zone Regular
Posts: 456
Joined: Sat May 17, 2008 11:00 pm
Location: Oxfordshire

Post Tue Sep 13, 2011 11:21 pm

Did you test the compression again once the car had been run?
Putting oil down the bores is how you test for worn rings or bores as the liquid slightly improves compression temporarily.