Hi there,
My 325 appears to have developed a misfire.
I pulled all the HT leads & found that the problem lies in the cylinder nearest the bulkhead.
I checked for a spark & all ok.
I then did a compression check - also ok, all about 150psi.
So am I right in thinking that it is a problem with the injector or could it be something else?
Any help would be appreciated.
Thanks
Stu
Misfire
Moderator: martauto
-
beemerstu84
- E30 Zone Newbie

- Posts: 77
- Joined: Sun Jan 01, 2006 11:00 pm
- Location: East Kilbride, Glasgow
-
daimlerman
- **BANNED**
- Posts: 15968
- Joined: Mon Feb 27, 2006 11:00 pm
- Location: Grumpy Old Man
Was the spark plug dry?
This would help confirm that the injector was playing up.
I can recommend 'Injectortune's' service,have a look in the Traders section.
This would help confirm that the injector was playing up.
I can recommend 'Injectortune's' service,have a look in the Traders section.
Youth is wasted on the young.
-
beemerstu84
- E30 Zone Newbie

- Posts: 77
- Joined: Sun Jan 01, 2006 11:00 pm
- Location: East Kilbride, Glasgow
Yeah the plug nearest the bulkhead was dry.
I was hoping to take the dodgy injector out & fit a replacement at the same time.
Anyone have 1 that I can fit to make sure that is the fault before getting them all refurbished?
Thanks
I was hoping to take the dodgy injector out & fit a replacement at the same time.
Anyone have 1 that I can fit to make sure that is the fault before getting them all refurbished?
Thanks
-
daimlerman
- **BANNED**
- Posts: 15968
- Joined: Mon Feb 27, 2006 11:00 pm
- Location: Grumpy Old Man
Have you tried tapping the base of the injector whilst the engine is running?
Youth is wasted on the young.
-
cee
- E30 Zone Regular

- Posts: 983
- Joined: Sun Aug 23, 2009 11:00 pm
- Location: Plymouth
Not sure if this is relevant now but may be of some use;



1990 Sterlingsilber 318iS - 146 bhp / 192 Nm
-
beemerstu84
- E30 Zone Newbie

- Posts: 77
- Joined: Sun Jan 01, 2006 11:00 pm
- Location: East Kilbride, Glasgow
Just tried tapping the injector, no difference I'm afraid.
The plugs all looked normal according 2 that chart
Thanks
Stu
The plugs all looked normal according 2 that chart
Thanks
Stu
-
beemerstu84
- E30 Zone Newbie

- Posts: 77
- Joined: Sun Jan 01, 2006 11:00 pm
- Location: East Kilbride, Glasgow
Hi there, I finally got round to changing my injector to sort the misfire.
Success with the misfire however under load it still boggs down.
Just wondering if anyone has any other ideas what to try?
Thanks
Stu
Success with the misfire however under load it still boggs down.
Just wondering if anyone has any other ideas what to try?
Thanks
Stu
