M20B25 Poor Running

Need technical Q/A then you're in the right place

Moderator: martauto

Kedge
Old Skooler
Old Skooler
Posts: 7698
Joined: Thu Jan 13, 2005 11:00 pm
Location: Leicestershire

Post Fri Sep 02, 2011 3:35 pm

Hi,

I was going to be posting a question any way about my touring as it really struggle to tick over until it's warm, but i was driving fine as soon as it was warm, thinking that could be a coolant temp sensor??

However today it's still doing the above however it's now driving like a bag of crap. Really hesistant and lumpy on anything other than full throttle and keeps stalling as soon as you stop.

Could this also be related to the coolant sensor or more TPS? Also a little suspect of the AFM meter since it's missing it's plastic cover, picking up a replacement on Sunday to rule that out.

Cheers
Dave
Image
'86 Polaris 316 M20B28 Rebuild
Instagram - Kedge85
User avatar
toby
E30 Zone Addict
E30 Zone Addict
Posts: 3609
Joined: Thu Aug 11, 2005 11:00 pm
Location: Kent

Post Fri Sep 02, 2011 3:39 pm

Check for air leaks in all the rubber bits around the air flow meter. Check all other basics like plugs etc
Image
daimlerman
**BANNED**
Posts: 15968
Joined: Mon Feb 27, 2006 11:00 pm
Location: Grumpy Old Man

Post Fri Sep 02, 2011 3:40 pm

Got a meter?

Check the resistance across the pins of the blue sensor with the engine cold,and with the engine hot.Should be a big difference in the reading.

To eliminate a wiring fault,repeat the check at the ECU plug.
Youth is wasted on the young.
Duke137
Married to the E30 Zone
Married to the E30 Zone
Posts: 7207
Joined: Sat Aug 29, 2009 11:00 pm

Post Fri Sep 02, 2011 3:53 pm

Possibly a split hose is my first thoughts....
How do you pronounce 'either'? I say 'either', but some say 'either'. Either is correct.
Jim320i
E30 Zone News / COTM Team
E30 Zone News / COTM Team
Posts: 10627
Joined: Sun Oct 25, 2009 11:00 pm
Location: Leicestershire

Post Fri Sep 02, 2011 4:01 pm

I'd suspect a hose too, once its warm, does it idle ok? I noticed on my chromie the other day it was idling really bad. Thought it was the valve timing I did the day before so suspected I hadnt timed them up properly... Then noticed the cable for the throttle body was sitting extremely loose and crookied, tightened that up and it was fine... So check over the throttloe cable as well. If you don't figure it out, we can have a nosey on sunday and see what we find.
Kedge
Old Skooler
Old Skooler
Posts: 7698
Joined: Thu Jan 13, 2005 11:00 pm
Location: Leicestershire

Post Fri Sep 02, 2011 5:10 pm

Can't find any sign of an airleak, intake boot is pretty new and I've sprayed a load of WD down to check the inlet manifold gaskets and no sign of anything there either.

It fairly warm at the moment and the coolant sensor is reading 571ohms.

At the moment while it warms it'll tick over nicely for 10-20secs and stall without warning, if I blip the throttle it'll attempt to hunt for idle again but really struggle and then stall.
Image
'86 Polaris 316 M20B28 Rebuild
Instagram - Kedge85
capri_rob
Married to the E30 Zone
Married to the E30 Zone
Posts: 9678
Joined: Tue Feb 19, 2008 11:00 pm
Location: South Staffordshire

Post Fri Sep 02, 2011 5:15 pm

If you've ruled out airleaks I'd be pulling the throttle body off, clean it out with carb cleaner until its spotless, clean out and/or swap the ICV for a known good one and clean out/reset the TPS. If it doesnt cure your problems it is stuff that makes sense to do anyway.

Would suggest swapping the AFM for a known good one as well especially as the cover is/was missing you don't know what messing with it the previous owner has done
Image

e30topless said : Proper BMW's have 4 headlights, last of the run was the E30 and E34/E32 anything after that is just complete shite
Kedge
Old Skooler
Old Skooler
Posts: 7698
Joined: Thu Jan 13, 2005 11:00 pm
Location: Leicestershire

Post Fri Sep 02, 2011 5:33 pm

Throttle body can be a job for tomorrow, I need a beer!

Found an ICV in stock but not sure how good it is though. Measured the resistance on both and they seem to rally with the guide at the top of the tech section.

Got two AFMs in stock but don't know what they are off, what part number should a facelift management AFM end in?
Image
'86 Polaris 316 M20B28 Rebuild
Instagram - Kedge85
Jim320i
E30 Zone News / COTM Team
E30 Zone News / COTM Team
Posts: 10627
Joined: Sun Oct 25, 2009 11:00 pm
Location: Leicestershire

Post Fri Sep 02, 2011 6:27 pm

Might also have a ICV over here mate, but would need to check. Not sure what type though but either from your engine or mine so you can try that out too if your unsure.
User avatar
toby
E30 Zone Addict
E30 Zone Addict
Posts: 3609
Joined: Thu Aug 11, 2005 11:00 pm
Location: Kent

Post Fri Sep 02, 2011 6:52 pm

Is the tps clicking when the throttle opens? Does the idle control valve hum with the ignition on?
Image
Kedge
Old Skooler
Old Skooler
Posts: 7698
Joined: Thu Jan 13, 2005 11:00 pm
Location: Leicestershire

Post Fri Sep 02, 2011 6:53 pm

toby wrote:Is the tps clicking when the throttle opens? Does the idle control valve hum with the ignition on?
Yea both of those happen.
Image
'86 Polaris 316 M20B28 Rebuild
Instagram - Kedge85
Duke137
Married to the E30 Zone
Married to the E30 Zone
Posts: 7207
Joined: Sat Aug 29, 2009 11:00 pm

Post Fri Sep 02, 2011 11:05 pm

Has the car been used or stood around for a while?
How do you pronounce 'either'? I say 'either', but some say 'either'. Either is correct.
Kedge
Old Skooler
Old Skooler
Posts: 7698
Joined: Thu Jan 13, 2005 11:00 pm
Location: Leicestershire

Post Sat Sep 03, 2011 1:50 am

It's been used in the last month or so but apparently been parked up for about 6 months prior to that.
Image
'86 Polaris 316 M20B28 Rebuild
Instagram - Kedge85
capri_rob
Married to the E30 Zone
Married to the E30 Zone
Posts: 9678
Joined: Tue Feb 19, 2008 11:00 pm
Location: South Staffordshire

Post Sat Sep 03, 2011 7:14 am

Did you change the fuel filter the other day ?

Might be worth pulling the sender/fuel pickup thing out of the tank and checking the gauze isnt clogged with crap - might be clutching at straws but easy enough to do, it can't hurt and its free 8)
Image

e30topless said : Proper BMW's have 4 headlights, last of the run was the E30 and E34/E32 anything after that is just complete shite
kman82
E30 Zone Regular
E30 Zone Regular
Posts: 967
Joined: Mon Sep 22, 2008 11:00 pm
Location: Oxford

Post Sat Sep 03, 2011 9:01 am

Kedge wrote: It fairly warm at the moment and the coolant sensor is reading 571ohms.
If you're problems are when the car is cold youve got to test the temp sensor when cold. Edit: at the ecu end too
Kedge
Old Skooler
Old Skooler
Posts: 7698
Joined: Thu Jan 13, 2005 11:00 pm
Location: Leicestershire

Post Sat Sep 03, 2011 6:19 pm

Problems are when it's hot & cold. Was already warm last night when I was fiddling so couldn't check what the sensor was doing when cold.

Had the meter on it today and was reading 2804 ohms & 571 when warm. Is that within workable parameters?

It was had a new fuel filter on it Rob, not had time today to get in at the pump though but will give that a shot.

Today I did manage to whip the throttle body off, but I decided to swap it with the one off the chromie since I know that works fine. Now it's worse when cold, fires n dies without revs, still drives the same, ok on a good amount of throttle but kangaroos a bit on light throttle. :mad:
Image
'86 Polaris 316 M20B28 Rebuild
Instagram - Kedge85
daimlerman
**BANNED**
Posts: 15968
Joined: Mon Feb 27, 2006 11:00 pm
Location: Grumpy Old Man

Post Sat Sep 03, 2011 7:07 pm

Kedge wrote:
Had the meter on it today and was reading 2804 ohms & 571 when warm. Is that within workable parameters?
That's fine,now we need to check it's wiring,so repeat the check at the ECU plug.

What we are now trying to establish is the possibility of a poor connection at C191,the round connector under the inlet manifold.
Youth is wasted on the young.
User avatar
toby
E30 Zone Addict
E30 Zone Addict
Posts: 3609
Joined: Thu Aug 11, 2005 11:00 pm
Location: Kent

Post Sat Sep 03, 2011 8:15 pm

So the distributor cap and rotor arm are fine?
Kangarooing often seems ignition related.
Image
Kedge
Old Skooler
Old Skooler
Posts: 7698
Joined: Thu Jan 13, 2005 11:00 pm
Location: Leicestershire

Post Sun Sep 04, 2011 11:18 am

Looks like I have an open circuit at the ECU, which pins am I looking at in particular on the C191?
Image
'86 Polaris 316 M20B28 Rebuild
Instagram - Kedge85
daimlerman
**BANNED**
Posts: 15968
Joined: Mon Feb 27, 2006 11:00 pm
Location: Grumpy Old Man

Post Sun Sep 04, 2011 11:59 am

Kedge wrote:Looks like I have an open circuit at the ECU, which pins am I looking at in particular on the C191?
If you carefully peel back the rubber boot on the blue sensor,you will see the wire colours that you are looking for,at both C191 and ECU.

C191 splits off the engine loom,it carries the injector wiring and both blue/brown temp sensor wires.
Youth is wasted on the young.
Curr946
E30 Zone Regular
E30 Zone Regular
Posts: 425
Joined: Tue Dec 23, 2008 11:00 pm
Location: Inverkeithing Fife

Post Sun Sep 04, 2011 12:04 pm

Kedge wrote:Looks like I have an open circuit at the ECU, which pins am I looking at in particular on the C191?

http://forum.roadfly.com/threads/387011 ... ost3870551

Pin# (Location) WireColor Size Function
1 (at three o'clock) BR/RD 0.5mm connects to coolant temp sensor;
from motronic control unit, pin #45 (coolant temp input)
2 (at one o'clock) BR/OR 0.5mm ground to coolant temp sensor;
from ground G103 on RH shock tower thru S701
Note that this is called a coolant temperature sensor,
not to be confused with coolant temperature sender.
3 (at eleven o'clock) BR/(BR/YL) 0.5mm ground to coolant temp sender;
from ground G200 under LH side of dash, above brake pedal
4 (at nine o'clock)BR/VI 0.5mm feeds the coolant temperature sender.
5 (at seven o'clock) RD/WT 2.5 hot side of the injectors
6 (at five o'clock) BR/WT 1.5mm connects to odd fuel injectors 1,3,5;
from motronic control unit, pin #16
7 (the center one) BR/YL 1.5mm connects to even fuel injectors 2,4,6;
from motronic control unit, pin #17
If your wife must learn to drive, don't stand in her way!
Kedge
Old Skooler
Old Skooler
Posts: 7698
Joined: Thu Jan 13, 2005 11:00 pm
Location: Leicestershire

Post Sun Sep 04, 2011 6:25 pm

Job done, was the AFM all along. Got one off Jim earlier and is running fine now, just maybe ticking over a bit high, can't remember what these tick over at bit it sits at around 950 rpm
Image
'86 Polaris 316 M20B28 Rebuild
Instagram - Kedge85
Jim320i
E30 Zone News / COTM Team
E30 Zone News / COTM Team
Posts: 10627
Joined: Sun Oct 25, 2009 11:00 pm
Location: Leicestershire

Post Sun Sep 04, 2011 6:27 pm

:cool: Glad to hear its sorted.
kman82
E30 Zone Regular
E30 Zone Regular
Posts: 967
Joined: Mon Sep 22, 2008 11:00 pm
Location: Oxford

Post Sun Sep 04, 2011 7:19 pm

Kedge wrote:Job done, was the AFM all along. Got one off Jim earlier and is running fine now, just maybe ticking over a bit high, can't remember what these tick over at bit it sits at around 950 rpm
seems a bit high still mate, Did you say you've checked the electrics on the TPS?
Kedge
Old Skooler
Old Skooler
Posts: 7698
Joined: Thu Jan 13, 2005 11:00 pm
Location: Leicestershire

Post Sun Sep 04, 2011 7:23 pm

The TPS is off my other car which ran perfect so can't see that being a cause, throttle is fully closed on tick over to.

The open circuit I was seeing before was because I'd been thick and forgot to reconnect the plug to the temp sensor after rechecking that, only realised when I got to Jims and saw it hanging off :o:
Image
'86 Polaris 316 M20B28 Rebuild
Instagram - Kedge85