M20B25 Poor Running
Moderator: martauto
-
Kedge
- Old Skooler

- Posts: 7698
- Joined: Thu Jan 13, 2005 11:00 pm
- Location: Leicestershire
Hi,
I was going to be posting a question any way about my touring as it really struggle to tick over until it's warm, but i was driving fine as soon as it was warm, thinking that could be a coolant temp sensor??
However today it's still doing the above however it's now driving like a bag of crap. Really hesistant and lumpy on anything other than full throttle and keeps stalling as soon as you stop.
Could this also be related to the coolant sensor or more TPS? Also a little suspect of the AFM meter since it's missing it's plastic cover, picking up a replacement on Sunday to rule that out.
Cheers
Dave
I was going to be posting a question any way about my touring as it really struggle to tick over until it's warm, but i was driving fine as soon as it was warm, thinking that could be a coolant temp sensor??
However today it's still doing the above however it's now driving like a bag of crap. Really hesistant and lumpy on anything other than full throttle and keeps stalling as soon as you stop.
Could this also be related to the coolant sensor or more TPS? Also a little suspect of the AFM meter since it's missing it's plastic cover, picking up a replacement on Sunday to rule that out.
Cheers
Dave
-
toby
- E30 Zone Addict

- Posts: 3609
- Joined: Thu Aug 11, 2005 11:00 pm
- Location: Kent
Check for air leaks in all the rubber bits around the air flow meter. Check all other basics like plugs etc

-
daimlerman
- **BANNED**
- Posts: 15968
- Joined: Mon Feb 27, 2006 11:00 pm
- Location: Grumpy Old Man
Got a meter?
Check the resistance across the pins of the blue sensor with the engine cold,and with the engine hot.Should be a big difference in the reading.
To eliminate a wiring fault,repeat the check at the ECU plug.
Check the resistance across the pins of the blue sensor with the engine cold,and with the engine hot.Should be a big difference in the reading.
To eliminate a wiring fault,repeat the check at the ECU plug.
Youth is wasted on the young.
-
Duke137
- Married to the E30 Zone

- Posts: 7207
- Joined: Sat Aug 29, 2009 11:00 pm
Possibly a split hose is my first thoughts....
How do you pronounce 'either'? I say 'either', but some say 'either'. Either is correct.
-
Jim320i
- E30 Zone News / COTM Team

- Posts: 10627
- Joined: Sun Oct 25, 2009 11:00 pm
- Location: Leicestershire
I'd suspect a hose too, once its warm, does it idle ok? I noticed on my chromie the other day it was idling really bad. Thought it was the valve timing I did the day before so suspected I hadnt timed them up properly... Then noticed the cable for the throttle body was sitting extremely loose and crookied, tightened that up and it was fine... So check over the throttloe cable as well. If you don't figure it out, we can have a nosey on sunday and see what we find.
-
Kedge
- Old Skooler

- Posts: 7698
- Joined: Thu Jan 13, 2005 11:00 pm
- Location: Leicestershire
Can't find any sign of an airleak, intake boot is pretty new and I've sprayed a load of WD down to check the inlet manifold gaskets and no sign of anything there either.
It fairly warm at the moment and the coolant sensor is reading 571ohms.
At the moment while it warms it'll tick over nicely for 10-20secs and stall without warning, if I blip the throttle it'll attempt to hunt for idle again but really struggle and then stall.
It fairly warm at the moment and the coolant sensor is reading 571ohms.
At the moment while it warms it'll tick over nicely for 10-20secs and stall without warning, if I blip the throttle it'll attempt to hunt for idle again but really struggle and then stall.
-
capri_rob
- Married to the E30 Zone

- Posts: 9678
- Joined: Tue Feb 19, 2008 11:00 pm
- Location: South Staffordshire
If you've ruled out airleaks I'd be pulling the throttle body off, clean it out with carb cleaner until its spotless, clean out and/or swap the ICV for a known good one and clean out/reset the TPS. If it doesnt cure your problems it is stuff that makes sense to do anyway.
Would suggest swapping the AFM for a known good one as well especially as the cover is/was missing you don't know what messing with it the previous owner has done
Would suggest swapping the AFM for a known good one as well especially as the cover is/was missing you don't know what messing with it the previous owner has done

e30topless said : Proper BMW's have 4 headlights, last of the run was the E30 and E34/E32 anything after that is just complete shite
-
Kedge
- Old Skooler

- Posts: 7698
- Joined: Thu Jan 13, 2005 11:00 pm
- Location: Leicestershire
Throttle body can be a job for tomorrow, I need a beer!
Found an ICV in stock but not sure how good it is though. Measured the resistance on both and they seem to rally with the guide at the top of the tech section.
Got two AFMs in stock but don't know what they are off, what part number should a facelift management AFM end in?
Found an ICV in stock but not sure how good it is though. Measured the resistance on both and they seem to rally with the guide at the top of the tech section.
Got two AFMs in stock but don't know what they are off, what part number should a facelift management AFM end in?
-
Jim320i
- E30 Zone News / COTM Team

- Posts: 10627
- Joined: Sun Oct 25, 2009 11:00 pm
- Location: Leicestershire
Might also have a ICV over here mate, but would need to check. Not sure what type though but either from your engine or mine so you can try that out too if your unsure.
-
toby
- E30 Zone Addict

- Posts: 3609
- Joined: Thu Aug 11, 2005 11:00 pm
- Location: Kent
Is the tps clicking when the throttle opens? Does the idle control valve hum with the ignition on?

-
Kedge
- Old Skooler

- Posts: 7698
- Joined: Thu Jan 13, 2005 11:00 pm
- Location: Leicestershire
Yea both of those happen.toby wrote:Is the tps clicking when the throttle opens? Does the idle control valve hum with the ignition on?
-
Duke137
- Married to the E30 Zone

- Posts: 7207
- Joined: Sat Aug 29, 2009 11:00 pm
Has the car been used or stood around for a while?
How do you pronounce 'either'? I say 'either', but some say 'either'. Either is correct.
-
Kedge
- Old Skooler

- Posts: 7698
- Joined: Thu Jan 13, 2005 11:00 pm
- Location: Leicestershire
It's been used in the last month or so but apparently been parked up for about 6 months prior to that.
-
capri_rob
- Married to the E30 Zone

- Posts: 9678
- Joined: Tue Feb 19, 2008 11:00 pm
- Location: South Staffordshire
Did you change the fuel filter the other day ?
Might be worth pulling the sender/fuel pickup thing out of the tank and checking the gauze isnt clogged with crap - might be clutching at straws but easy enough to do, it can't hurt and its free
Might be worth pulling the sender/fuel pickup thing out of the tank and checking the gauze isnt clogged with crap - might be clutching at straws but easy enough to do, it can't hurt and its free

e30topless said : Proper BMW's have 4 headlights, last of the run was the E30 and E34/E32 anything after that is just complete shite
-
kman82
- E30 Zone Regular

- Posts: 967
- Joined: Mon Sep 22, 2008 11:00 pm
- Location: Oxford
If you're problems are when the car is cold youve got to test the temp sensor when cold. Edit: at the ecu end tooKedge wrote: It fairly warm at the moment and the coolant sensor is reading 571ohms.
-
Kedge
- Old Skooler

- Posts: 7698
- Joined: Thu Jan 13, 2005 11:00 pm
- Location: Leicestershire
Problems are when it's hot & cold. Was already warm last night when I was fiddling so couldn't check what the sensor was doing when cold.
Had the meter on it today and was reading 2804 ohms & 571 when warm. Is that within workable parameters?
It was had a new fuel filter on it Rob, not had time today to get in at the pump though but will give that a shot.
Today I did manage to whip the throttle body off, but I decided to swap it with the one off the chromie since I know that works fine. Now it's worse when cold, fires n dies without revs, still drives the same, ok on a good amount of throttle but kangaroos a bit on light throttle.
Had the meter on it today and was reading 2804 ohms & 571 when warm. Is that within workable parameters?
It was had a new fuel filter on it Rob, not had time today to get in at the pump though but will give that a shot.
Today I did manage to whip the throttle body off, but I decided to swap it with the one off the chromie since I know that works fine. Now it's worse when cold, fires n dies without revs, still drives the same, ok on a good amount of throttle but kangaroos a bit on light throttle.
-
daimlerman
- **BANNED**
- Posts: 15968
- Joined: Mon Feb 27, 2006 11:00 pm
- Location: Grumpy Old Man
That's fine,now we need to check it's wiring,so repeat the check at the ECU plug.Kedge wrote:
Had the meter on it today and was reading 2804 ohms & 571 when warm. Is that within workable parameters?
What we are now trying to establish is the possibility of a poor connection at C191,the round connector under the inlet manifold.
Youth is wasted on the young.
-
toby
- E30 Zone Addict

- Posts: 3609
- Joined: Thu Aug 11, 2005 11:00 pm
- Location: Kent
So the distributor cap and rotor arm are fine?
Kangarooing often seems ignition related.
Kangarooing often seems ignition related.

-
Kedge
- Old Skooler

- Posts: 7698
- Joined: Thu Jan 13, 2005 11:00 pm
- Location: Leicestershire
Looks like I have an open circuit at the ECU, which pins am I looking at in particular on the C191?
-
daimlerman
- **BANNED**
- Posts: 15968
- Joined: Mon Feb 27, 2006 11:00 pm
- Location: Grumpy Old Man
If you carefully peel back the rubber boot on the blue sensor,you will see the wire colours that you are looking for,at both C191 and ECU.Kedge wrote:Looks like I have an open circuit at the ECU, which pins am I looking at in particular on the C191?
C191 splits off the engine loom,it carries the injector wiring and both blue/brown temp sensor wires.
Youth is wasted on the young.
-
Curr946
- E30 Zone Regular

- Posts: 425
- Joined: Tue Dec 23, 2008 11:00 pm
- Location: Inverkeithing Fife
Kedge wrote:Looks like I have an open circuit at the ECU, which pins am I looking at in particular on the C191?
http://forum.roadfly.com/threads/387011 ... ost3870551
Pin# (Location) WireColor Size Function
1 (at three o'clock) BR/RD 0.5mm connects to coolant temp sensor;
from motronic control unit, pin #45 (coolant temp input)
2 (at one o'clock) BR/OR 0.5mm ground to coolant temp sensor;
from ground G103 on RH shock tower thru S701
Note that this is called a coolant temperature sensor,
not to be confused with coolant temperature sender.
3 (at eleven o'clock) BR/(BR/YL) 0.5mm ground to coolant temp sender;
from ground G200 under LH side of dash, above brake pedal
4 (at nine o'clock)BR/VI 0.5mm feeds the coolant temperature sender.
5 (at seven o'clock) RD/WT 2.5 hot side of the injectors
6 (at five o'clock) BR/WT 1.5mm connects to odd fuel injectors 1,3,5;
from motronic control unit, pin #16
7 (the center one) BR/YL 1.5mm connects to even fuel injectors 2,4,6;
from motronic control unit, pin #17
If your wife must learn to drive, don't stand in her way!
-
Kedge
- Old Skooler

- Posts: 7698
- Joined: Thu Jan 13, 2005 11:00 pm
- Location: Leicestershire
Job done, was the AFM all along. Got one off Jim earlier and is running fine now, just maybe ticking over a bit high, can't remember what these tick over at bit it sits at around 950 rpm
-
Jim320i
- E30 Zone News / COTM Team

- Posts: 10627
- Joined: Sun Oct 25, 2009 11:00 pm
- Location: Leicestershire
-
kman82
- E30 Zone Regular

- Posts: 967
- Joined: Mon Sep 22, 2008 11:00 pm
- Location: Oxford
seems a bit high still mate, Did you say you've checked the electrics on the TPS?Kedge wrote:Job done, was the AFM all along. Got one off Jim earlier and is running fine now, just maybe ticking over a bit high, can't remember what these tick over at bit it sits at around 950 rpm
-
Kedge
- Old Skooler

- Posts: 7698
- Joined: Thu Jan 13, 2005 11:00 pm
- Location: Leicestershire
The TPS is off my other car which ran perfect so can't see that being a cause, throttle is fully closed on tick over to.
The open circuit I was seeing before was because I'd been thick and forgot to reconnect the plug to the temp sensor after rechecking that, only realised when I got to Jims and saw it hanging off
The open circuit I was seeing before was because I'd been thick and forgot to reconnect the plug to the temp sensor after rechecking that, only realised when I got to Jims and saw it hanging off

