The feed wire to the A/C pump isn't constant. It feeds for a split second them drops out again then a few seconds later it will come back and on it goes. Has anyone got any ideas.
It's an 86 325i.
A/C Feed Problem
Moderator: martauto
-
mrLEE30
- E30 Zone Team Member

- Posts: 6589
- Joined: Tue Jan 18, 2005 11:00 pm
- Location: Sweating buckets in Bahrain
the feed wire or the wire that tells the clutch to engage?
if its the latter then this only sends the "engage " signal when then temp is highre then set.
what colour is the wire?
if its the latter then this only sends the "engage " signal when then temp is highre then set.
what colour is the wire?

-
turkeysneck
- E30 Zone Regular

- Posts: 441
- Joined: Sat Nov 27, 2010 11:00 pm
The wire that tells the clutch to engage, it starts off purple at the heater box then changes to black and white.
Not quite sure what you mean about higher than set ?
Not quite sure what you mean about higher than set ?
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Aircon only actually works when instructed to do so by the thermostat attached to the temp. knob.turkeysneck wrote: Not quite sure what you mean about higher than set ?
For your problem, check out what the pressure switches on the drier are doing.
-
turkeysneck
- E30 Zone Regular

- Posts: 441
- Joined: Sat Nov 27, 2010 11:00 pm
The problem is way before the pressure switches. I've fixed it now, it was a lack of feed to the temp regulator.
