A/C Feed Problem

Need technical Q/A then you're in the right place

Moderator: martauto

turkeysneck
E30 Zone Regular
E30 Zone Regular
Posts: 441
Joined: Sat Nov 27, 2010 11:00 pm

Post Thu Aug 25, 2011 10:37 pm

The feed wire to the A/C pump isn't constant. It feeds for a split second them drops out again then a few seconds later it will come back and on it goes. Has anyone got any ideas.
It's an 86 325i.
mrLEE30
E30 Zone Team Member
E30 Zone Team Member
Posts: 6589
Joined: Tue Jan 18, 2005 11:00 pm
Location: Sweating buckets in Bahrain

Post Fri Aug 26, 2011 8:18 am

the feed wire or the wire that tells the clutch to engage?

if its the latter then this only sends the "engage " signal when then temp is highre then set.

what colour is the wire?
Image
turkeysneck
E30 Zone Regular
E30 Zone Regular
Posts: 441
Joined: Sat Nov 27, 2010 11:00 pm

Post Fri Aug 26, 2011 12:25 pm

The wire that tells the clutch to engage, it starts off purple at the heater box then changes to black and white.

Not quite sure what you mean about higher than set ?
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49360
Joined: Mon Jan 10, 2005 11:00 pm

Post Fri Aug 26, 2011 2:21 pm

turkeysneck wrote: Not quite sure what you mean about higher than set ?
Aircon only actually works when instructed to do so by the thermostat attached to the temp. knob.
For your problem, check out what the pressure switches on the drier are doing.
turkeysneck
E30 Zone Regular
E30 Zone Regular
Posts: 441
Joined: Sat Nov 27, 2010 11:00 pm

Post Fri Aug 26, 2011 7:19 pm

The problem is way before the pressure switches. I've fixed it now, it was a lack of feed to the temp regulator.