elp!!! m20 early 2.5 conversion car wont start..........

Need technical Q/A then you're in the right place

Moderator: martauto

MOODY
E30 Zone Regular
E30 Zone Regular
Posts: 484
Joined: Wed Feb 22, 2006 11:00 pm
Location: HEAVEN.....STOKE ON TRENT.....

Post Tue Aug 16, 2011 6:43 pm

:x hi there all i have just fitted a early 2.5 hi comp engine in my h reg 320i, i have gone to kick it up but there is nothing the the relay is buzzing and the idle control valve and dash lights up, i have sparked it of the starter and it starts, any ideas what it could be?
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49360
Joined: Mon Jan 10, 2005 11:00 pm

Post Tue Aug 16, 2011 6:50 pm

MOODY wrote: i have sparked it of the starter and it starts, any ideas what it could be?
Doesn't make sense! Does it start or doesn't it? Or do you mean oit won't start from the key?
User avatar
punko
E30 Zone Newbie
E30 Zone Newbie
Posts: 123
Joined: Wed Dec 30, 2009 11:00 pm

Post Tue Aug 16, 2011 11:06 pm

check the wiring on the starter make sure you have the 2 smaller wires the right way around, if so check what happens at the wire from the ignition barrel with a multimeter.
MOODY
E30 Zone Regular
E30 Zone Regular
Posts: 484
Joined: Wed Feb 22, 2006 11:00 pm
Location: HEAVEN.....STOKE ON TRENT.....

Post Wed Aug 17, 2011 3:17 am

brian it wont start from the key, and its only got 1 small wire on the starter, and 2 on the + plus
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49360
Joined: Mon Jan 10, 2005 11:00 pm

Post Wed Aug 17, 2011 9:05 am

Are you using a facelift or pre facelift loom with this engine?
If facelift, is it the one that was in the car before the engine swap?
MOODY
E30 Zone Regular
E30 Zone Regular
Posts: 484
Joined: Wed Feb 22, 2006 11:00 pm
Location: HEAVEN.....STOKE ON TRENT.....

Post Wed Aug 17, 2011 12:39 pm

Brianmoooore wrote:Are you using a facelift or pre facelift loom with this engine?
If facelift, is it the one that was in the car before the engine swap?
ive used the pre facelift mate?
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49360
Joined: Mon Jan 10, 2005 11:00 pm

Post Wed Aug 17, 2011 12:45 pm

Then about the only thing that can be wrong is you haven't connected the black/yellow from the loom to the correct terminal on the starter motor.
Black/green is best connected to the 13mm nut closest to the starter motor body.