elp!!! m20 early 2.5 conversion car wont start..........
Moderator: martauto
-
MOODY
- E30 Zone Regular

- Posts: 484
- Joined: Wed Feb 22, 2006 11:00 pm
- Location: HEAVEN.....STOKE ON TRENT.....
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Doesn't make sense! Does it start or doesn't it? Or do you mean oit won't start from the key?MOODY wrote: i have sparked it of the starter and it starts, any ideas what it could be?
-
punko
- E30 Zone Newbie

- Posts: 123
- Joined: Wed Dec 30, 2009 11:00 pm
check the wiring on the starter make sure you have the 2 smaller wires the right way around, if so check what happens at the wire from the ignition barrel with a multimeter.
-
MOODY
- E30 Zone Regular

- Posts: 484
- Joined: Wed Feb 22, 2006 11:00 pm
- Location: HEAVEN.....STOKE ON TRENT.....
brian it wont start from the key, and its only got 1 small wire on the starter, and 2 on the + plus
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Are you using a facelift or pre facelift loom with this engine?
If facelift, is it the one that was in the car before the engine swap?
If facelift, is it the one that was in the car before the engine swap?
-
MOODY
- E30 Zone Regular

- Posts: 484
- Joined: Wed Feb 22, 2006 11:00 pm
- Location: HEAVEN.....STOKE ON TRENT.....
ive used the pre facelift mate?Brianmoooore wrote:Are you using a facelift or pre facelift loom with this engine?
If facelift, is it the one that was in the car before the engine swap?
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Then about the only thing that can be wrong is you haven't connected the black/yellow from the loom to the correct terminal on the starter motor.
Black/green is best connected to the 13mm nut closest to the starter motor body.
Black/green is best connected to the 13mm nut closest to the starter motor body.
