When squirting the windscreen, only the driver's jet works. The head light washers don't squirt either and leaks shoot out of the valves at the bulkhead end of the bonnet and behind the driver's side lights.
Do they do this because the nozzles are blocked?
Can I unblock the nozzles? Bath in Bi carb of soda? Batch in cola?
How do I get the headlight wipers to wipe?
Water squirters.... arghhhhh!
Moderator: martauto
-
Simon
- E30 Zone Team Member

- Posts: 14939
- Joined: Sun Jan 09, 2005 11:00 pm
- Location: South Wales
Usually the T pieces /N/R valves in the system leak, and as you say, if the nozzles are blocked up, then the pressure will cause the water to exit at the easiest route. Change the T pieces and the nozzles (only a couple of quid from the dealers), and all should be ok again!
There's lots of things that could be preventing the headlamp wipers from working, the relay mounted on the washer bottles playing up for a start, but the biggest problem, especially for motors that haven't been used for a while is seized motors, remove the motors, and rebuild with plenty of grease, also give the spindle a damn good cleaning, and this is the main problem, with corrosion in the shaft.
There's lots of things that could be preventing the headlamp wipers from working, the relay mounted on the washer bottles playing up for a start, but the biggest problem, especially for motors that haven't been used for a while is seized motors, remove the motors, and rebuild with plenty of grease, also give the spindle a damn good cleaning, and this is the main problem, with corrosion in the shaft.

-
johnna
- E30Zone Irregular
- Posts: 1715
- Joined: Sat Sep 17, 2005 11:00 pm
- Location: In the hole
Thanks Simon 
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
The headlamp washers are controlled entirely by the right hand headlamp motor, and will not work unless this wiper works,(or work continuously, if it seizes in the wrong place).
The headlamp wipers themselves are only supposed to work every fifth time or so that you use the windscreen washers, when the lights are on.
The headlamp wipers themselves are only supposed to work every fifth time or so that you use the windscreen washers, when the lights are on.
-
beardymat
- E30 Zone Squatter

- Posts: 1979
- Joined: Tue Jun 14, 2005 11:00 pm
- Location: sheffield, city of steel, and rust apparently
wow thats one big ass avatar!!!!!!!!!!!!!!!!!!!!
P.S. welcome to the madhouse/zone
P.S. welcome to the madhouse/zone
No longer self employed but still available for welding duties.
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
It is a bit on the big side. Would be appreciated if you could cut it down a bit, please.beardymat wrote:wow thats one big ass avatar!!!!!!!!!!!!!!!!!!!!
-
johnna
- E30Zone Irregular
- Posts: 1715
- Joined: Sat Sep 17, 2005 11:00 pm
- Location: In the hole
Tah Daaahhhh!!!
I never thought the avatar would be that big.
Cheers for the advice.
I never thought the avatar would be that big.
Cheers for the advice.
-
BrAdZ
- E30 Zone Regular

- Posts: 645
- Joined: Mon May 02, 2005 11:00 pm
- Location: Bedford/Milton Keynes
only my passenger side one works :S

-
johnna
- E30Zone Irregular
- Posts: 1715
- Joined: Sat Sep 17, 2005 11:00 pm
- Location: In the hole
I swapped them no bother, but I also installed some new y peices and new hose, removing the vavles. I bought it from a home brew kit supplier. Total cost of repair Ԛ£1.50!
-
garyp_E30_325i
- E30 Zone Regular

- Posts: 724
- Joined: Mon Jun 20, 2005 11:00 pm
- Location: Sunny (I wish!) Glasgow
I've also had problems with my skooshies.
T-valves keep blowing (and once they're gone that's it) even though I can't find a blockage in the tubes / y-piece. So I'm gonna replace everything including the nozzles themselves.
I removed my headlight wipers - useless & ugly. I've been told that the head light washers use the same pump as the windscreen washers and if you disconnect the relay for the headlight washers you get all the power of the pump onto your windscreen - handly, especially in the forthcoming weather. Haven't tried it yet but gonna.

T-valves keep blowing (and once they're gone that's it) even though I can't find a blockage in the tubes / y-piece. So I'm gonna replace everything including the nozzles themselves.
I removed my headlight wipers - useless & ugly. I've been told that the head light washers use the same pump as the windscreen washers and if you disconnect the relay for the headlight washers you get all the power of the pump onto your windscreen - handly, especially in the forthcoming weather. Haven't tried it yet but gonna.
Sh*t, my repair is costing me Ԛ£6 from BMW...I bought it from a home brew kit supplier. Total cost of repair Ԛ£1.50!
'89 325i - was an SE but not anymore, was bronze-beige metallic (yeuch!) but now techno-violet (thankfully)
'89 Toyota Corolla GTi-16 - track, hillclimb & sprint car (yeeha!)
'08 Buell XB12Ss - American engineering at it's 'best'... good fun though
'89 Toyota Corolla GTi-16 - track, hillclimb & sprint car (yeeha!)
'08 Buell XB12Ss - American engineering at it's 'best'... good fun though
