reply!!!!!! is head gasket
Moderator: martauto
-
darren318is
- E30 Zone Newbie

- Posts: 75
- Joined: Thu May 19, 2005 11:00 pm
- Location: dundalk, ireland
head gasket gone in my 318is
. do you have to replace head bolts with new ones? i wandt rto replace my timing chain but mechanic says its ok thers no signs of wear and plenty of tension cars done 108ooo miles what do you think? ive seen a post on here about chain snapping wat wud cause this?what should i look out for and apart from w pump and thermostat should i replace any thing else.head will be coming off to get tested so thinkin of port an polish can people do that without my engine(send head to them) what money should this cost noting that they dont have to do any stripping an rebuilding. where in ireland could i get this done....................................................................................................................so that enough questions for you 
-
Adammcf
- E30 Zone Squatter

- Posts: 1578
- Joined: Sun Jan 23, 2005 11:00 pm
You'll need new head bolts but I think the chains on those engines are fine for loads of miles so you wont need to worry about changing that.
If the head is off make sure you put in new valve stem seals and change all the other seals and gaskets for new ones - just to prevent any leaks for the next few years.
If the head is off make sure you put in new valve stem seals and change all the other seals and gaskets for new ones - just to prevent any leaks for the next few years.
-
adamS
- E30 Zone Regular

- Posts: 437
- Joined: Mon Jan 10, 2005 11:00 pm
- Location: Washington near Newcastle
But...while the head is off you might as well do the chain and guides etc. Peace of mind and all that!
-
darren318is
- E30 Zone Newbie

- Posts: 75
- Joined: Thu May 19, 2005 11:00 pm
- Location: dundalk, ireland
so wat about the cost of the port and polish where in ireland do border motor works do this
-
darren318is
- E30 Zone Newbie

- Posts: 75
- Joined: Thu May 19, 2005 11:00 pm
- Location: dundalk, ireland
so ur all too late for port an polish info. just need to know well mechanic wants to know do bmw dealers do a set of new gaskets for use to replace all broken gaskets wen head comes off..... or do i have to order each individually
