Post
Tue Jul 27, 2010 9:43 pm
To add to Daimlerman's post: When you start the engine, set the heater control to full hot, the fan to '2', the top two sliders to the left and the bottom slider to the right. Monitor the air coming from the heater into the footwell, and ensure that it has the beginnings of warmth within a couple of minutes of starting the engine. Also keep a close eye on the temperature gauge.
If not warm air is forthcoming, and the gauge is climbing, you have an airlock in the head, and if the M20 is a 2.5, you are in danger of cracking the head.
The airlock can be cleared by removing the top heater hose at the bulkhead, placing your hand flat across the coolant bottle filler neck, and blowing gently into the overflow hose, until coolant flows both from the hose and the heater stub.