Hi Guys
I'm stuck trying to swap my old drums for 325disks. Someone here must have done it!
Basically, BMW say that its the same cable for drums and for the mini drums in the disks but they have completely different ends on them.
Can anyone find a BMW part number for the two different types or is there a way to just modify the end of the cable??
Any advice would be great, currently my car is sitting on stands with half an axel attached.
Thanks
Stuart
DISK DRUM BRAKES HELP
Moderator: martauto
-
stulane
- E30 Zone Newbie

- Posts: 202
- Joined: Tue Jul 05, 2005 11:00 pm
- Location: Eastbourne, E Sussex
-
E30Mark
- E30 Zone Team Member

- Posts: 8107
- Joined: Sun Jan 09, 2005 11:00 pm
- Location: Wimborne, Dorset
I assume you mean handbrake cable. They are different between the drum / disc setup.
part number:- 32.41.1.158.421 ETK says about Ԛ£15 ea.
part number:- 32.41.1.158.421 ETK says about Ԛ£15 ea.
-
stulane
- E30 Zone Newbie

- Posts: 202
- Joined: Tue Jul 05, 2005 11:00 pm
- Location: Eastbourne, E Sussex
Thats the part number i found as well but i couldn't find a part number for the cable with drums to compare the cables.
Does anyone know how to replace the handbrake cables as i found it difficult to pull the cable through the sleeve, do you replace the the sleeve at the same time??
Does anyone know how to replace the handbrake cables as i found it difficult to pull the cable through the sleeve, do you replace the the sleeve at the same time??
-
A1BMW325iSport
- E30 Zone Addict

- Posts: 4239
- Joined: Mon Jan 10, 2005 11:00 pm
- Location: Mid Wales
yeah i replaced the whole lot on mine
-
Treeman612
- E30 Zone Newbie

- Posts: 238
- Joined: Thu Jan 20, 2005 11:00 pm
- Location: Newbury, Berks
Hi, I,ve just done a drum to disc conversion, and despite being told the cables are the same, they aint! Changing cables is easy, except that the outer sleeve gets pretty corroded to the tubes in the body where they enter the transmission tunnel - WD40 and Mole grips did it 4 me, but I had the axle carrier/diff out, so access may be a problem. The cable ends have different fittings at the wheel ends between discs and drums - changing the ends sounds like 2 much hassle 2 me - get new, unstretched cables if you're going to the trouble of fitting discs (oh, and why not upgrade to Goodridge braided hoses while you're at it?)
-
stulane
- E30 Zone Newbie

- Posts: 202
- Joined: Tue Jul 05, 2005 11:00 pm
- Location: Eastbourne, E Sussex
Is there much difference and how much extra Ԛ£Ã”šÃ‚£Ãƒ”šÃ‚£ are we talking?(oh, and why not upgrade to Goodridge braided hoses while you're at it?)
I'm changing the whole rear axel and diff (for a LSD
Thanks for your advice!
-
Treeman612
- E30 Zone Newbie

- Posts: 238
- Joined: Thu Jan 20, 2005 11:00 pm
- Location: Newbury, Berks
Check out the forum group buy on Goodridge hoses - they were around Ԛ£48 including postage for the six line set (you'll need 6 lines for the disc set up) - Missy30 organised the group buy, but I don't know if she's got any sets left. Haven't tried them out yet, but other zoners feedback so far has been very positive.
Good luck with the swop-over!!
Good luck with the swop-over!!

