Normally I would use air sanders, die grinders and even a lathe but not everyone has these tools.
Anyway here is the wheels in desperate need of a refurb. They are 14inch BBSs and are suffering from bad gutter rash.

First thing to do is remove the tyres from the wheels. Your local tyre shop can do this.
_______________________________________________Get some basic tools. You will need.
jack and jack stands
wheel brace
saftey goggles
gloves
Some hand files
Sand paper
filler
etch primer
high fill primer
paint
caustic soda
bucket big enough for one wheel
High powered hose or preferably a gurney

The wheels should be clean before working on them, this helps show up imperfections and makes the job nicer to do.
Put in your gloves and safety goggles
Fill the large bucket up with water and add some caustic soda. I added about a cup full. Place the wheel in the caustic soda solution and the water will start to bubble like soft drink. Now you cant leave it in there all day. Apparently caustic soda eats aluminum. I left them in there for 20 mins. Remove the wheels and hose with your high pressure water gun or gurney.
Here you can clearly see the difference. I tried everything to clean the filth off these. Degreaser, thinners, prepsol you name it. Nothing would remove this gunk. Until I tried caustic soda. Pretty impressive isnt it?

_______________________________________________Now jack up your E30 and remove one of the rear tyres. Important you must lift both rear wheels off the ground. Mount the rim that needs refurbing on the car. Inspect the damage to the rims, as you can see this one is pretty bad.

Start the car and place it in gear.
_______________________________________________Now using your hand file place it on the edge of the rim rotating it around the bead, We are using your E30 as a lathe by moving the file across the damaged lip. Its important to give it a nice round lip and not square. If the kerbing is real bad you wont be able to remove all of it. What we are trying to do is remove the majority of it.


Once we have finished with the file its time to move on to the sand paper. I start with a very course paper 40p and work my way up the grades. 40, 80, 120, 180 , 240 and 320p. Now this will remove all the file marks and some of the minor imperfections.

This is what you will be left with.

The missing bits in the edges will need filling and then sanding, for this I use the QBond pictured above. Its a like a epoxy filler and it goes off in seconds as is super super strong.


Now its time to clean the wheels ready for primer. Prepsol is the cleaner of choice for this.

Now we are ready to prime the wheels, before so you must give the wheels a thorough cleaning with the prepsol. For thos of you who dont have the facilities to paint, you could drop the wheels off at your friendly panel shop to do the rest.
Wheels in highfill primer.


From here the wheels will get a guide coat and some wet sanding.
Stay tuned.
P.S you guys think BBS wheels are hard to keep clean? Try painting the buggers. Very hard to avoid dry spots and super easy to get runs. A real nightmare to paint. Might take it nice and easy when painting. I think lots of light coats is in order for these beauties.
Mike
Stay tuned
Mike













