So I put the crank in, having left the conrods and pistons in the bores. Put a crank cap on each end, and connected the con rods. Having oiled the bearings it then turns etc, so I turn the block over (working on the floor till my engine stand arrives) to see how much the pistons are sticking up.........and they aren't
However before I jump to coonclusions, I cannot work out what the crank is from, what combination of 2.5 pistons, 2.5 rods, 2.5 block and ?? crank will have the pistons lower down the bores?
Also what do you lot think, re ebay, because it looks increasingly like I have been sold a 2.5 crank under the impression it's a 2.7 one??? it was probably 3 months ago.
Any way I'm off out to take a pic to put up, any support or comment gratefully recieved aaaaaaggggggggggghhhhhhhhhhh and the plan was only just starting
Here we go this is at TDC -


By my calculations the top edge of the pistons should be 3mm clear of the block. Check out his description http://cgi.ebay.co.uk/ws/eBayISAPI.dll? ... 4549072666
I really hope he means 525e eta, there is no such thing as a 525i eta, is there?Here for sale is a 525i ETA crank which i bought myself for 75 pounds off a guy when i was doing my 2.7 engine conversion









