camshaft for 318is?

[Dan318-is]

i am port polishing both my inlet and exhaust manifolds next yeasr but have been told it would also be a good idea to uprate the cams in my IS, any idea which are good makes and even if they exist??

[jaistanley]

Try looking at newman or cat cams. I think CAT definately do re-grinds and new from blank cams. The re-grinds will be best value.

Gopd luck man,

Jai

[Simon13]

Cams again nearly non existant and very expensive if u do find any!

Hartge don't make theirs any more.

[Dan318-is]

kool

thanks dor the advice guys think it just advance the timing slightly

[Demlotcrew]

http://www.kempower.be/bmw/M42B181.htm

A

[Dan318-is]

bloomin heck

cheers mate!

[SwirlyE30]

7.097,00 Euros
Stage 4

POWER (hp DIN) 185






sweeeet.


Although you can get that sort of power for far less

[Dan318-is]

ye like 250 quid for an m20 lump plus a few bolt ons lol

[Kedge]

Sounds sweet, but would rather put that kind of money towards a mental engine conversion on a project car and keep the iS standard.

[Dan318-is]

i have to agree there pal

although it would be one of a kind the m42 can only have so much power

you could get twice the gains from an engine a wee bit bigger for a tleast a quarter of that

still beserk tho