Was hoping it'd need just a couple of plates welded in to patch the rusty holes:

After some poking around and removal of the pedals it was clear that it was a bit worse:




So after getting in about it with various cutting tools it now looks like this:

There are a couple more small bits to cut out from the inside, its getting a bit tight for space though. Any more and I'd have had to move the dash, loom and probably the engine - No thanks!
Going to finish the cutting this weekend and hopefully find time to fabricate some bits to get welded in.
I'd welcome some useful comments. I've already been told that I'm insane, wasting my time and should have re-shelled it.





















