SPRINGS

[trex]

SORRY Quick question my sport is lowerd 60mm all round
i want to put the original springs back in is this a job i could
do myself if so what do i do
thanks
AL

[maxfield]

Rears are a piece of cake.

The fronts will need a spring compressor.

[trex]

how much would it cost roughly to pay to get it done

[maxfield]

About £25 a corner I guess?

[trex]

a nice one ill just pay so thanks anyway

[town325i]

where abouts are you

[trex]

ireland dublin

[m4xos]

Rears are a piece of cake.

The fronts will need a spring compressor.

if i had the opposite question and asked i have a 325 sport and have standard springs and want to lower it, then i would still need compressors??!!!! ive done rear ones better always left it to my mates to do them 4 me!!

[maxfield]

Yes, you will still need spring compressor.

Have you ever seen a fully loaded spring slip?

[town325i]

french spring are the worst ive had one slip out the compressors and tw4t me on the shin i did jump about and shout lots for an hour

[magpie]

an easy job.wish you were a bit nearer
and i'd show you how it's done and what you need while doing it.

[konfuzion]

Yes, you will still need spring compressor.

Have you ever seen a fully loaded spring slip?

Seen one slip out of the compressors and fly across the garage I used to work at and take a chunk out of the brick wall like a sledgehammer (was off the front of a 7.5 ton truck) Just glad I wasn't in the firing line!



Regards,

Ian

[magpie]

i let one fly in my pup yrs off a billy'd up 2.8 capri leg...
savage.and v, dangerous.

[m4xos]

no i havent seen it personally but my dad has told me its very dangerous!! haha, i like the fact of that!!!