Diamond Shwartz, 325i, cars done 80k, but the engines an older high comp one with 62K on the clocks from which the car came from. 14" BBS, some silly and bad side sweep exhaust and quickshift. It has the dark grey cottony type sport interior (is this houndstooth?) and a slightly bluey tint carpet, with standart creamy/grey headlining.
She needs some work, which is in the pipelines for after crimbo!
Heres a pic of it.

[/img]Now these pics show a bit of the work involved.

[/img]
[/img]
[/img]
[/img]I have a nice plan for her. First is the cambelt/waterpump/tensioner and sort out a new radiator and viscous etc to make the cooling work ... better. At the same time, a good service, making sure everythings connected, some deisel oil to slowly clean as much boggage in the engine as possible. Basically a re-vamp over the engine.. New gear-linkage too, and whatever else i can think of to be done during that time.
Next is a revamp over the suspension and running gear. Looking into getting some good shocks/springs all round, new good brake disks, pads, braided cables, bushes for everything and possibly new bearings (doesn't need some yet i think... also probably to my Z3 rack conversion at that point. By then i would have repainted my alloys rims to match this one (which some of you may remember) and get them on...
So that means a nice re-vampage on the whole car! Almost... i'll try not miss anything.
BTB 6 branch, scorpion exhaust.
Then its the bloody bodywork. New front wings and bonnet and a new rear valance (and maybe front as its slightly bent) and spray the iS lip to get a nicer look/finish. I may even do a full exterior respray. I need to sort out a classic rear arch scrape sooo.... thats also gonna get looked at.
Then the simple stuff. Tech1 skirts, alpina spoiler, other little touches.
INTERIOR..... needs to be leather. Probably get a tailor to do a nice custom job...
Alloys....
After all that, the debate stands to go carboning..... bonnet, maybe tech2 kit if the group buy continues and go for a 2 tone Diamond Shwartz/Carbon... but thats welllll into the future
Final consideration would be..... boost....
But, one step at a time! Step 1 including the engine overhaul is gonna be done in Jan. Using moneys left over from crimbo to purchase necessary parts to fix everything and then fix her up. May have to run into January payday to do this tho!
Whilst mates are over at uni, i dont spend so much, so hoping to have this sorted by summer! My hope is to get it immaculate by then.... for my 21st! Then i'll consider making a UK trip to meet everyone at a Zone gathering!
Looking forward to the new Zone for the Journal!!






