My New Project/Toy.... 325i

Show off your pride and joy here

Moderator: martauto

Nay
Channel Island Crew
Channel Island Crew
Posts: 3988
Joined: Wed Aug 13, 2008 11:00 pm

Post Fri Dec 19, 2008 3:46 pm

Got my 325i on monday. Thought i'd give you a little insight into it!!

Diamond Shwartz, 325i, cars done 80k, but the engines an older high comp one with 62K on the clocks from which the car came from. 14" BBS, some silly and bad side sweep exhaust and quickshift. It has the dark grey cottony type sport interior (is this houndstooth?) and a slightly bluey tint carpet, with standart creamy/grey headlining.

She needs some work, which is in the pipelines for after crimbo!

Heres a pic of it.

Image
Image[/img]


Now these pics show a bit of the work involved.
Image
Image[/img]

Image
Image[/img]

Image
Image[/img]

Image
Image[/img]


I have a nice plan for her. First is the cambelt/waterpump/tensioner and sort out a new radiator and viscous etc to make the cooling work ... better. At the same time, a good service, making sure everythings connected, some deisel oil to slowly clean as much boggage in the engine as possible. Basically a re-vamp over the engine.. New gear-linkage too, and whatever else i can think of to be done during that time.

Next is a revamp over the suspension and running gear. Looking into getting some good shocks/springs all round, new good brake disks, pads, braided cables, bushes for everything and possibly new bearings (doesn't need some yet i think... also probably to my Z3 rack conversion at that point. By then i would have repainted my alloys rims to match this one (which some of you may remember) and get them on...

So that means a nice re-vampage on the whole car! Almost... i'll try not miss anything.

BTB 6 branch, scorpion exhaust.

Then its the bloody bodywork. New front wings and bonnet and a new rear valance (and maybe front as its slightly bent) and spray the iS lip to get a nicer look/finish. I may even do a full exterior respray. I need to sort out a classic rear arch scrape sooo.... thats also gonna get looked at.

Then the simple stuff. Tech1 skirts, alpina spoiler, other little touches.

INTERIOR..... needs to be leather. Probably get a tailor to do a nice custom job...

Alloys....

After all that, the debate stands to go carboning..... bonnet, maybe tech2 kit if the group buy continues and go for a 2 tone Diamond Shwartz/Carbon... but thats welllll into the future :D

Final consideration would be..... boost....

But, one step at a time! Step 1 including the engine overhaul is gonna be done in Jan. Using moneys left over from crimbo to purchase necessary parts to fix everything and then fix her up. May have to run into January payday to do this tho!

Whilst mates are over at uni, i dont spend so much, so hoping to have this sorted by summer! My hope is to get it immaculate by then.... for my 21st! Then i'll consider making a UK trip to meet everyone at a Zone gathering!

Looking forward to the new Zone for the Journal!! :D
Image

Uni is killing the project.
ImysE30
Married to the E30 Zone
Married to the E30 Zone
Posts: 22478
Joined: Mon Jul 07, 2008 11:00 pm
Location: Derby Massive!!

Post Fri Dec 19, 2008 3:56 pm

Good luck with the project dude :thumb:

Will look very nice when re-vamped :cool:
Current Fleet:

E30 335i Turbo M3 Convertible Replica
leeparkes
Married to the E30 Zone
Married to the E30 Zone
Posts: 9535
Joined: Thu Jan 03, 2008 11:00 pm
Location: Black country

Post Fri Dec 19, 2008 5:19 pm

nice project!
where are you from?
Cypriotgeeza wrote:I done both my mates in my old 318is
felt so proud,even tried it with a E30 325i and got put in my place.. :o:
Nay
Channel Island Crew
Channel Island Crew
Posts: 3988
Joined: Wed Aug 13, 2008 11:00 pm

Post Fri Dec 19, 2008 5:37 pm

leeparkes wrote:nice project!
where are you from?
Jersey mate. Only down in the channel surround by a rather large river.... only thing that keeps me away from a meet :(
Image

Uni is killing the project.
cliffybabe
Powered by Nelly
Powered by Nelly
Posts: 10020
Joined: Sun Dec 18, 2005 11:00 pm
Location: Croydon

Post Fri Dec 19, 2008 5:58 pm

looks good crying out for some 15's or 16's though
Image
Considering Selling the Cabby, looks like its gonna go
Ollie_bwoii
Married to the E30 Zone
Married to the E30 Zone
Posts: 8695
Joined: Sat May 17, 2008 11:00 pm
Location: Northampton

Post Sat Dec 20, 2008 5:01 pm

Looks good! :D More pictures please???
bss325i
E30 Zone Team Member
E30 Zone Team Member
Posts: 24532
Joined: Sat Jan 20, 2007 11:00 pm
Location: London/Surrey

Post Sat Dec 20, 2008 5:06 pm

Pic of the interiorare needed to tell if its houndstooth or not.

Good choice on the BTB, non of that hottuning rip off crap!

Have you checked the important areas for rot? Inside roof, inner rear arches, scuttle etc?
http://www.bmrperformance.co.uk

BMW and MINI specialist - Gatwick
Baz666
E30 Zone Addict
E30 Zone Addict
Posts: 3516
Joined: Fri Feb 29, 2008 11:00 pm
Location: Ipswich, Suffolk

Post Sat Dec 20, 2008 6:07 pm

Can see why you wanted my bonnet now. looking good tho fella :cool:
Image
E46 328ci, sport bumpers, 19" style 95`s
aj_mckay
E30 Zone Squatter
E30 Zone Squatter
Posts: 1782
Joined: Sun Nov 11, 2007 11:00 pm
Location: Winchester

Post Sun Dec 21, 2008 10:53 am

Plenty of work to be getting on with! Hope you've got deep pockets. Should be good if you can get everything on your list done though. Stick those red BBS you had done on it for now 8)
Nay
Channel Island Crew
Channel Island Crew
Posts: 3988
Joined: Wed Aug 13, 2008 11:00 pm

Post Mon Dec 22, 2008 2:35 am

aj_mckay wrote:Plenty of work to be getting on with! Hope you've got deep pockets. Should be good if you can get everything on your list done though. Stick those red BBS you had done on it for now 8)
A lot of my mates are saying that? Do you reckon it'll go ok? I was actually thinking of red detailing, but it could be a bit too much. Well once some of it is done i will. Looking forward to getting her in the garage and getting the engine sorted, then the suspension after.
Image

Uni is killing the project.
Nay
Channel Island Crew
Channel Island Crew
Posts: 3988
Joined: Wed Aug 13, 2008 11:00 pm

Post Mon Dec 22, 2008 2:37 am

Ollie_bwoii wrote:Looks good! :D More pictures please???
In good time! Waiting for the sun to shine a bit... :?
Image

Uni is killing the project.
Nay
Channel Island Crew
Channel Island Crew
Posts: 3988
Joined: Wed Aug 13, 2008 11:00 pm

Post Mon Dec 22, 2008 2:40 am

bss325i wrote:Pic of the interiorare needed to tell if its houndstooth or not.

Good choice on the BTB, non of that hottuning rip off crap!

Have you checked the important areas for rot? Inside roof, inner rear arches, scuttle etc?
I've checked as much as i can. There are no "holes" as such under the arches, but thats gonna get looked at before the work commences. If they are gone (even slightly) how hard is it to fix?

There is a minor leak somewhere into the passanger footwell. Its not obvious where it is though (needs a better investigation) but RKive's and Splinter's have had it and there was a clear little rust patch on the bottom inside the door. Mine doesn't seem to have anything there...
Image

Uni is killing the project.
aj_mckay
E30 Zone Squatter
E30 Zone Squatter
Posts: 1782
Joined: Sun Nov 11, 2007 11:00 pm
Location: Winchester

Post Mon Dec 22, 2008 2:12 pm

NayC wrote:There is a minor leak somewhere into the passanger footwell. Its not obvious where it is though (needs a better investigation) but RKive's and Splinter's have had it and there was a clear little rust patch on the bottom inside the door. Mine doesn't seem to have anything there...
Likely that there's a hole rusted through the bulk head under where the fuse box is at the front. Take the carpet out and have a good look.

I think you'll be FAR better off assessing the condition of the shell properly before you even think about doing anything on the engine/running gear. Get the shell/bodywork good as the oily bits are far easier to bring up to scratch afterwards.
Nay
Channel Island Crew
Channel Island Crew
Posts: 3988
Joined: Wed Aug 13, 2008 11:00 pm

Post Tue Dec 23, 2008 1:27 pm

aj_mckay wrote:
NayC wrote:There is a minor leak somewhere into the passanger footwell. Its not obvious where it is though (needs a better investigation) but RKive's and Splinter's have had it and there was a clear little rust patch on the bottom inside the door. Mine doesn't seem to have anything there...
Likely that there's a hole rusted through the bulk head under where the fuse box is at the front. Take the carpet out and have a good look.

I think you'll be FAR better off assessing the condition of the shell properly before you even think about doing anything on the engine/running gear. Get the shell/bodywork good as the oily bits are far easier to bring up to scratch afterwards.
Point. It does need a good look into the shell, but all the classic places seem to be fine.
Image

Uni is killing the project.
User avatar
pnd
E30 Zone Squatter
E30 Zone Squatter
Posts: 1801
Joined: Sat Nov 12, 2005 11:00 pm

Post Tue Dec 23, 2008 1:35 pm

this is going to cost to fix up you must be one rich student.
Nay
Channel Island Crew
Channel Island Crew
Posts: 3988
Joined: Wed Aug 13, 2008 11:00 pm

Post Fri Dec 26, 2008 5:14 pm

pnd wrote:this is going to cost to fix up you must be one rich student.
Not a student anymore! Now a professional *junior* software developer! :lol:

Basically, over time it will be done in stages. Nearly time to get her in for a full on engine haul over! Just getting the 320i in first to patch it up and put it up for sale :(
Image

Uni is killing the project.