Finally got it done this morning, big thanks to Paul (sheps) for the dyno runs/time.
Manifold was fitted to my 325i touring, before fitting, only mods were a full sebring exhaust system, zone chip and an induction kit.
Obviously a good strong engine to start with, engine came from an auto with just over 100k on the clock.
Red line shows pre hottuning, purple with hottuning.
No adjustments were made to the fuelling, Paul pointed out that the car is running rich at some points since fitting the manifold, and obviously a remap would sort this out.
All in all, it's shown an improvement, good increase in torque, and it looks much nicer in the engine bay than the cast manifold.












