Complete suspension refresh....

Post Mon Dec 17, 2007 3:24 pm

I have a 1990 318i that I'm going to race, its done 120k so I'd like to refresh most of the suspension components.

Currently in the post are a complete set of poly bushes and the bits for a rear disc conversion but as the same time I want to replace all the bearings, ball joints, nuts bolts etc etc....

Dampers will be coil overs if that makes any difference.

if you can give me a list of what you think I need and the prices we can take it from their.

Thanks,

Richard

Post Mon Dec 17, 2007 4:14 pm

Will it be a full race car or just track day car?

And how much do you want to spend?

As you can have fully adjustable to little adjustment.

Post Mon Dec 17, 2007 4:18 pm

Its a race car but will be road legal. Suspension needs to be single unit, i.e. no remote's
I'm thinking GAZ or H&R coil overs at the moment.

That said the dampers arnt the 1st thing, I'd rather get the other bits sorted 1st.

Post Mon Dec 17, 2007 4:24 pm

You can go solid rear end, diff bush and subframe bushes.

Then you can get get adjustable rear trailing arm bushes.

Then front wishbone bushes, preferably M3, you can go solid. M3 gives more castor.

Front adjustable top mounts.

I'll do some research and get prices for you.

Post Mon Dec 17, 2007 5:03 pm

I can only go for components that were stock on 318i or 320i so the plan is to just refresh what is there.

Bushes are free, dampers are free as long as they are self contained single units.

details of 2007 reg's can be found here, 2008 regs are very similar.
http://www.selocmotorsport.com/

Post Mon Dec 17, 2007 5:34 pm

I'm not too sure what's allowed and what's not to be honest.

Where's Jimmyc when you need him

Post Mon Dec 17, 2007 5:36 pm

Black_Potato wrote:I can only go for components that were stock on 318i or 320i so the plan is to just refresh what is there.

How do you get away with the coilovers, out of interest?

Post Tue Dec 18, 2007 12:13 am

because they are mentioned specifically as ok in the regs, if its not mentioned then the assumption should be the default BMW part.

Post Tue Dec 18, 2007 12:20 am

Its Jimmy you need for the regs, also ther are recognised suppliers for the PBMW challenge for most parts