Hi, im new the the forum and just bought an E-Reg E30 325i SE
I've done a search but couldnt find anything about fitting a LSD.
Does anyone know how hard it is to fit a LSD?
Is it something you could do yourself?
If it was put in a garage how many hours labour would that cost?
Cheers
Andy
Fitting a LSD
Moderator: martauto
-
Jhonno
- Homo Hair
- Posts: 20362
- Joined: Mon Jan 10, 2005 11:00 pm
- Location: FLAT, FLAT, FLAT!!
bout 3 hrs work if you can wield a spanner and a socket
-
AndyMack
- E30 Zone Newbie
- Posts: 66
- Joined: Wed May 25, 2005 11:00 pm
- Location: Glasgow
So its not too difficult.Jhonno wrote:bout 3 hrs work if you can wield a spanner and a socket
Is there a "fitting a lsd" article on this site?
-
E30Adam
- Married to the E30 Zone
- Posts: 8483
- Joined: Sun Dec 19, 2004 11:00 pm
- Location: Bournemouth
All depends on how competent you are at mechanics.
I'd say it was an easy job with a few pitfalls but a beginner should not attempt this.
Also DECENT lifting and support equipment is required to avoid injury or the car falling on your head.
I'd say it was an easy job with a few pitfalls but a beginner should not attempt this.
Also DECENT lifting and support equipment is required to avoid injury or the car falling on your head.
2.8 Litre M20 powered - Essen Sie meinen Staub biatch