do both convertible and 2 door E30's use the same motorsport kit except for the lower cill's/side skirts?
post & pre face lift?
M-Sport kit fitment
Moderator: martauto
-
fowler
- Boost Junkie
- Posts: 3468
- Joined: Mon Jan 10, 2005 11:00 pm
- Location: New Addington/Croydon
Pre face lift is a tech 1 kit ona convertible
i believe the tech 2 kit is alos different.
with the cab in you sig pic it would be a gues its and F plate so it could be either tech 1 or tech as they came out the factory not knowing what they wanted on them
i believe the tech 2 kit is alos different.
with the cab in you sig pic it would be a gues its and F plate so it could be either tech 1 or tech as they came out the factory not knowing what they wanted on them
EX A-Tech Workshop bitch !!!
325i Turbo touring (Aka Project Fridge)
gone but not forgotten
325i Turbo touring (Aka Project Fridge)
gone but not forgotten
-
320iAN
- E30 Zone Camper

- Posts: 1395
- Joined: Sat Sep 16, 2006 11:00 pm
- Location: West Scotland
Hi yip thats my car but it's a 1990 H reg "chromie"
am i right in thinking then that the front, rear and side pod's from any 2 door motorsport will fit my car
just the lower cills/skirts won't they shall have to be ones from a cabby? .. if it where a tech 2 kit
or
should i just trace down some tech one front and rear bumpers and fit them with tech 2 side pod's & skirts.
am i right in thinking then that the front, rear and side pod's from any 2 door motorsport will fit my car
or
should i just trace down some tech one front and rear bumpers and fit them with tech 2 side pod's & skirts.

-
beardymat
- E30 Zone Squatter

- Posts: 1979
- Joined: Tue Jun 14, 2005 11:00 pm
- Location: sheffield, city of steel, and rust apparently
cabs have deeper sills so use different side skirts although it is possible to fit the ones from a 2 door kit with a little stretching. depends how fussy you are. also the later tech 2 cars had a different rear arch profile so if you fit that kit to your car the rear bumper will need a little work to make it fit properly at the arch.
No longer self employed but still available for welding duties.
-
320iAN
- E30 Zone Camper

- Posts: 1395
- Joined: Sat Sep 16, 2006 11:00 pm
- Location: West Scotland
thank's think i'll save me some bother and just find a tech one cabby kit 

