Can anyone tell me if the pipe that takes the fluid to the clutch cylinder
on the gear box bellhousing are the same diameter across the range.
Have an E32 730i gearbox that i will be using in my 325i , when i get round to doing the 535i conversion. but the person that supplied the box cut the pipe about 9 inches from the cylinder
Clutch cylinder.
Moderator: martauto
-
gooner1
- Out humping Reindeer
- Posts: 13280
- Joined: Fri Apr 14, 2006 11:00 pm
- Location: Northampton.For my sins.
-
DRIFTBOY
- E30 Zone Addict
- Posts: 3131
- Joined: Mon May 22, 2006 11:00 pm
- Location: Kent
My E34 535i clutch hose had same diameter pipe and fittings as my 325i one. 
Jeremy Clarkson wrote:...but it drives the front wheels. Theee wrooong wheels!
da4x4turbo wrote:I raced a vivaro on the motorway once in a 318is.... and lost!!!
-
SPADGE
- Married to the E30 Zone
- Posts: 7373
- Joined: Wed Aug 09, 2006 11:00 pm
- Location: Milton Keynes, Bucks
Yes mate just use the pipe already attached to your car
Engine conversions, Auto to manual conversions, parts, servicing etc etc... For anything e30 call 07718 901737
-
gooner1
- Out humping Reindeer
- Posts: 13280
- Joined: Fri Apr 14, 2006 11:00 pm
- Location: Northampton.For my sins.
Thanks for that mate, chances are they are the same then.
-
gooner1
- Out humping Reindeer
- Posts: 13280
- Joined: Fri Apr 14, 2006 11:00 pm
- Location: Northampton.For my sins.
Cheers Spadge One less thing to worry about. Just took me best part of 3 hours to remove the rubber doughnut bit from bell housing cos supplier had left 3 inches of propshaft on the end of gearbox as well. 