gear linkage bushes.

[bentleyag]

dose anyone know where i can get bushes for my gear input linkage??[/code]

[d6dph]

Dealer, And not expensive either.

[Templ8e30]

http://www.realoem.com/bmw/showparts.do ... g=25&fg=05

Cheers,

Iain T

[Brianmoooore]

13 is the part you need, but change the little oil seal (not shown in this diagram) on the gearbox selector shaft as well.
If part 13 has been modified from your original, then you'll need part 10 as well.

[Andy335Touring]

Whilst you are in there...... i'd change 2 and 8 as well, possibley 6 if you are being really fussy

[Andy335Touring]

oh and 2 x 11 and 2 x 14(plastic washers ?)

[edster]

don't know what number it is but the Knuckle right up at the gear box, with a large barrel clip securing it. I didn't replace it & it remained like stirring apot of soup until I did. If you've got the box out then please do it. If not then you've got to drop the prop', exhaust & loosen off the back support to lower the back end of the box.

[bentleyag]

thanks done it in situ. remove box drop prop?????????????

[ifty]

which part number is required to cure a floppy gear leaver? even when in gear it has so much play in it.

[Brianmoooore]

13 is the part you need, but change the little oil seal (not shown in this diagram) on the gearbox selector shaft as well.
If part 13 has been modified from your original, then you'll need part 10 as well.