Where do i top up my clutch fluid on my 325 sport? Its been sat for a while and has now completely lost the clutch!!!
Any help appreciated!!
Thanks
TOPPING UP CLUTCH FLUID???
Moderator: martauto
-
marty1979
- E30 Zone Newbie

- Posts: 108
- Joined: Mon Nov 06, 2006 11:00 pm
- Location: Bristol
Oh crumbs, it sounds like your master or slave cylinder might be dead if you've lost all you fluid. The resovoir is on the drivers side of the engine with a little black cap on the top.
-
buckz2001
- E30 Zone Newbie

- Posts: 24
- Joined: Mon Oct 17, 2005 11:00 pm
the small container next to the water bottle and the top of the strut? nwhats my next move? can i just top the fluid up????
cheers mate
cheers mate
-
Ziggy
- E30 Zone Team Member

- Posts: 11534
- Joined: Mon Jan 10, 2005 11:00 pm
- Location: floating round my tin can...
Yes - just above the steering column.
As has already been said though; if the fluid's really empty, it's because it's leaking from somewhere. You could top it up, but it'll probably need bleeding. But seeing as you'll be replacing the slave / master (/both) cylinder, you'll be needing to do that anyway. Is there clutch fluid on / under the pedals?
Could also be that the clutch has seized rather than the fluid's leaked...
As has already been said though; if the fluid's really empty, it's because it's leaking from somewhere. You could top it up, but it'll probably need bleeding. But seeing as you'll be replacing the slave / master (/both) cylinder, you'll be needing to do that anyway. Is there clutch fluid on / under the pedals?
Could also be that the clutch has seized rather than the fluid's leaked...
E30 in need of wiring loom smoke since April '11...
-
marty1979
- E30 Zone Newbie

- Posts: 108
- Joined: Mon Nov 06, 2006 11:00 pm
- Location: Bristol
The little bottle at the top of the strut, that's the one. Well, if you've lost all your clutch fluid there must be a reason, usually a leaking clutch master or slave cylinder. Both have to be replaced if this is the case, but you could top up with fluid and keep and eye on it to see what happens, chances are you'll find that the resovoir will be empty again pretty soon. Also you'll have to bleed the system as there will be air sucked into the pipes, for all the trouble it's worth you may aswell replace the slave and master cylinder now anyway as they're not that expensive from GSF.
HTH
*EDIT* too slow
HTH
*EDIT* too slow
-
buckz2001
- E30 Zone Newbie

- Posts: 24
- Joined: Mon Oct 17, 2005 11:00 pm
how could do you bleed the system if i just topped it up for the time being? Its just i've gotta rolling road the car at uni on friday for an assignment i'm doing....so need a quick bodge then i can sort it out properly later on..
any ideas???????
any ideas???????
-
buckz2001
- E30 Zone Newbie

- Posts: 24
- Joined: Mon Oct 17, 2005 11:00 pm
any ideas on cost of master and slave cylinders?????? i'm a poor student..........
-
Ziggy
- E30 Zone Team Member

- Posts: 11534
- Joined: Mon Jan 10, 2005 11:00 pm
- Location: floating round my tin can...
You might not need to bleed it, but the bleed screw's on the slave cylinder. Have you actually checked the reservoir's empty? & I assume you've contemplated the merits of dynoing a car that's been sat around for ages
For costs, see gsfcarparts.com
For costs, see gsfcarparts.com
E30 in need of wiring loom smoke since April '11...
-
buckz2001
- E30 Zone Newbie

- Posts: 24
- Joined: Mon Oct 17, 2005 11:00 pm
haven't got much of a choice....need to rolling road it as part of a project....if i don't use it i'll fail my course. why what will the sit around for ages dynoing effects be????
so if i top up the fluid and bleed it it should be ok? and yes the reservoirs empty.
thanks for the help mate

so if i top up the fluid and bleed it it should be ok? and yes the reservoirs empty.
thanks for the help mate
-
Ziggy
- E30 Zone Team Member

- Posts: 11534
- Joined: Mon Jan 10, 2005 11:00 pm
- Location: floating round my tin can...
When I replaced both my cylinders, I just bunged em on, filled it up & drove away... there was a bit of air in the system but it got rid of itself in no time & was drivable straight away anyway. So you'll quite likely just get away with filling it up! But keep an eye on it - it'll leak again & if the seals have had a chance to dry out it may well p1ss out quick time! If there's fluid around the pedals it's the master cyl, otherwise there'll be a puddle under the car & it's the slave. But I'd change both anyway.
I'd want to put a few gentle miles in before getting it on the dyno... & do a decent fluid service, check your tyres etc before you go anywhere...
I'd want to put a few gentle miles in before getting it on the dyno... & do a decent fluid service, check your tyres etc before you go anywhere...
E30 in need of wiring loom smoke since April '11...
