failed first time
i have a decent idea on how to do it but right now my tool collection is practically none existent.
how the hell do you get the bearing out? do i need a set of pullers?
is it relatively a simple job? any advice would be great.
Moderator: martauto










Ricksta wrote:Its between a 35mm and 36mm socket! and its a pain to find one that big that also fits within the outer assembly!! did both mine 2 weeks ago, and had a real mission getting the socket, then it was too big to fit inside the hub! so we had to use a lathe to take off a skim round the outside of the socket!!




Once the caliper(13 &15mm), carrier(19mm), disk and hub nut are removed, simply bolt the wheel back on to the hub and use the wheel as leverage to pull the bearing from the stub axle.ric325i wrote: how the hell do you get the bearing out? do i need a set of pullers?


