Coupole of 1987 questions

General E30 related discussions -
Please put technical questions in E30 Tech Help forum below

Moderator: martauto

choppa7
E30 Zone Regular
E30 Zone Regular
Posts: 971
Joined: Wed Jan 31, 2007 11:00 pm
Location: Newcastle Upon Tyne

Post Mon Feb 12, 2007 10:31 am

Hey people

I just picked up my first e30 on Saturday for the grand price of £165
Image

Couple of things I'm unsure of (well a couple at the minute lol)

1) When I opened the boot on sunday morning, there was what appeared to be condensation on the inside of the boot lid?

Is this normal with there being no lining to the boot or does this mean something else do you think???

2) I'm looking to fit an M3 kit but will it fit the 4 door ok for the skirts?

3) in 5th gear if I put my foot down the revs rise but the speed doesnt, is thiis the clutch slipping, if so are there any cheap online suppliers?

Thats all for now, I'll pop any more I think of up in due course.

Cheers people! :cool:
Geeman
Married to the E30 Zone
Married to the E30 Zone
Posts: 7641
Joined: Sun Jan 09, 2005 11:00 pm
Location: Grimsby, Lincolnshire

Post Mon Feb 12, 2007 10:36 am

1) Yes, it's common on older cars... either the boot seal, or rear light seals have failed and are letting in the damp

2) Do you mean the Mtech kit... or an M3 kit? M3 kit will NOT fit, but Mtech 1 kit (as opposed to the Mtech 2 kit) will fit without too many problems.

3) Sounds very much like a clutch slip problem. Try GSF or ECP to get a replacement.

Nice motor for not much dosh!

Welcome to the Zone! 8)
E30Mark
E30 Zone Team Member
E30 Zone Team Member
Posts: 8107
Joined: Sun Jan 09, 2005 11:00 pm
Location: Wimborne, Dorset

Post Mon Feb 12, 2007 10:40 am

Looks like Geeman beat me to it...

Condensation in the boot is common, check the side pockets are not full of water, the sunroof drains in here...

Rear light seals also tend to leak, as do boot lid seal if the boot lid isn't adjusted properly.

Now when you say M3 kit, do you mean Mtech II kit? as on my tourer :cool:
Mtech II will fit yours, but you have to change loads of bits because yours is a pre-facelift car, your better off sourcing a Mtech I kit.

Image

this is the M3

Image
1 & 2 bed flats in Bournemouth areas, with parking
PM for details
choppa7
E30 Zone Regular
E30 Zone Regular
Posts: 971
Joined: Wed Jan 31, 2007 11:00 pm
Location: Newcastle Upon Tyne

Post Mon Feb 12, 2007 11:26 am

Thanks people, good to know the boot is a simple and common thing.

I wasnt sure which kit I meant to be honest but Mtech 1 is the kit I'm now looking to source as I dont want to be altering bits everywhere. I'm just after making it look a bit better.

Got to say, this is one of the most helpful and friendliest forums I've come across. Been a member of the mazda 323 and 106 Rallye forum and trying to get help is like drawing teeth.

very much appreciate the help 8)
Speedtouch
Old Skooler
Old Skooler
Posts: 14130
Joined: Tue Feb 14, 2006 11:00 pm
Location: Canterbury

Post Mon Feb 12, 2007 11:36 am

Welcome to the Zone, choppa! Which model of E30 is yours? Looks a bit like my first one, which was a B-reg ('84) 320i. They must be addictive, as I've owned two others since then...

Normally with a slipping clutch, you'll often get a smell of burning wafting into the cockpit. 8O
///M aurice
ECU Upgrade EPROM Chips, £40 posted within the UK. Note these are not Zone chips.
viewtopic.php?f=6&t=279421
Theo
Old Skooler
Old Skooler
Posts: 10735
Joined: Wed Jun 01, 2005 11:00 pm
Location: Kent

Post Mon Feb 12, 2007 11:38 am

Looks just like my car when bought it - this is it now after a few mods...

Image
choppa7
E30 Zone Regular
E30 Zone Regular
Posts: 971
Joined: Wed Jan 31, 2007 11:00 pm
Location: Newcastle Upon Tyne

Post Mon Feb 12, 2007 12:00 pm

OOoooh Theo, thats a bit sexual!!!

Is that the Mtech 1 Kit? Thats how I'd pictured it, pretty standard just fitted with OEM kit and lowered a bit and drop the 325 lump into it.

i'm fairly sure that there was a slight waft of a burning clutch just after I floored it and it slipped.

Does anyone kow roughly how much a new clutch would be, a ball park figure would be fine?
Theo
Old Skooler
Old Skooler
Posts: 10735
Joined: Wed Jun 01, 2005 11:00 pm
Location: Kent

Post Mon Feb 12, 2007 12:13 pm

Yeah thats a tech 1 kit fitted to it, glad you like it! Well worth it in the end. I also replaced all the chrome trim on the car with black 'shadowline' trim. Replacing those horrible cream (previously chrome) windscreen surrounds with black ones makes a massive difference alone.

I dropped the car about 40mm which is a nice height, although at the time, the rear springs weren't fitted, but it doesn't really show on that picture.

One thing I would say though, is to make sure your car is solid in all the key places before spending loads on getting it to look the way you want. Check the rear inner arches, the bulkhead are behind the glovebox, jacking points, sills etc etc.