rear pad warning lamp

Need technical Q/A then you're in the right place

Moderator: martauto

gaszman
E30 Zone Meets/Events Team
E30 Zone Meets/Events Team
Posts: 3111
Joined: Wed Jan 03, 2007 11:00 pm
Location: Outside of Scummerland !

Post Sun Feb 11, 2007 2:03 pm

ive just got this damm light on all the time now . ok its not the wire checked that not dash re solderd the two joints on dash so do i just take the damm bulb out. shes a 320 i touring 1990 :o:
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49360
Joined: Mon Jan 10, 2005 11:00 pm

Post Sun Feb 11, 2007 2:09 pm

If the 220 ohm resistor has been resoldered, then there's a poor connection in the pad sensor loop. You have two sensors - front left and rear right. Either you have an open circuit pad sensor, a short to earth, or a bad connection in one of the plug/sockets where the pad sensors plug in.
If the pad sensor wires aren't dressed properly they will rub through on the inside of the wheel.
gaszman
E30 Zone Meets/Events Team
E30 Zone Meets/Events Team
Posts: 3111
Joined: Wed Jan 03, 2007 11:00 pm
Location: Outside of Scummerland !

Post Sun Feb 11, 2007 8:32 pm

thank you will check this out