Hi my 320i auto is running at last but I have a question about temp gauge.When the engine was in bits the gauge sat in the middle of the dial,now it's running it goes to the red but when you take off the brown plug it drops.Top hoses were hot.What is possible cause?
I think I will rewrite my wee story
Hi my 320i auto is running at last but I have a question about temp gauge.When the engine was in bits the gauge sat in the middle of the dial with ignition on.When you turn on the ignition and start the engine the needle goes to the middle,then as the engine gets hot it goes to the red.The demisters are cold which means an air lock that I know.I was wondering what part I need that fits the brown plug,hopefully that will cure the strange temp.needle setting.
I have read the many posts re.air locks and will have a go later.Thanks
running at last
Moderator: martauto
-
jcjdavis1
- E30 Zone Camper

- Posts: 1128
- Joined: Thu Apr 13, 2006 11:00 pm
- Location: Paisley Scotland
Last edited by jcjdavis1 on Thu Feb 08, 2007 7:18 pm, edited 1 time in total.

-
E30Mark
- E30 Zone Team Member

- Posts: 8107
- Joined: Sun Jan 09, 2005 11:00 pm
- Location: Wimborne, Dorset
Air lock. Turn the interior heater on, and re-bleed
The brown sender is for the temp gauge.... what did you expect to happen when you disconnected it?
The brown sender is for the temp gauge.... what did you expect to happen when you disconnected it?
1 & 2 bed flats in Bournemouth areas, with parking
PM for details
PM for details
-
Chris-W
- E30 Zone Team Member

- Posts: 7219
- Joined: Tue May 24, 2005 11:00 pm
- Location: South Cheshire
-
jcjdavis1
- E30 Zone Camper

- Posts: 1128
- Joined: Thu Apr 13, 2006 11:00 pm
- Location: Paisley Scotland
Hi I have edited my post

-
jcjdavis1
- E30 Zone Camper

- Posts: 1128
- Joined: Thu Apr 13, 2006 11:00 pm
- Location: Paisley Scotland
Hi I was working on car today and it still has temp needle in middle of gauge when ignition switched on then goes to the red after a while.I take it that the sender unit needs replacing.Chris-W wrote:As above, but am a bit confused by the needle having been in the middle of the gauge whilst the engine was 'in bits'?
If the bottom hose going through the bulk head is warm not hot would the air lock likely be in the engine block/radiator?


