engine temp e30 m3
Moderator: martauto
-
tobias
- E30 Zone Regular

- Posts: 326
- Joined: Tue Aug 29, 2006 11:00 pm
- Location: isle of man
hi guys i was wondering if anyone can help.
my m3 gets up to temp really quick (probably about 3-5 miles). it then sits between half to three quarter on the temp gauge.
it by no means overheatsbut i have a feeling it shouldnt be getting that warm so quick??
any comments welcome
regards toby
my m3 gets up to temp really quick (probably about 3-5 miles). it then sits between half to three quarter on the temp gauge.
it by no means overheatsbut i have a feeling it shouldnt be getting that warm so quick??
any comments welcome
regards toby
-
maxfield
- Old Skooler

- Posts: 15185
- Joined: Sat Nov 26, 2005 11:00 pm
- Location: Mansfield
No it doesn't warm up as quick as that on ym dads m3

-
stuartgallafant
- E30 Zone Addict

- Posts: 4531
- Joined: Tue Mar 29, 2005 11:00 pm
- Location: Costa del Croydon
-
tobias
- E30 Zone Regular

- Posts: 326
- Joined: Tue Aug 29, 2006 11:00 pm
- Location: isle of man
no air in cooling system but thermostat was next port of call. just wanted some opinions first?
i think thermostat is about £60+vat at bmw
i think thermostat is about £60+vat at bmw
-
maxfield
- Old Skooler

- Posts: 15185
- Joined: Sat Nov 26, 2005 11:00 pm
- Location: Mansfield
-
herman
- E30 Zone Regular

- Posts: 486
- Joined: Mon May 02, 2005 11:00 pm
- Location: Manchester
Make sure your electric fan has not gone, when I bought my M3 that warmed up quick. Then when I was stuck in traffic it overheated. When your moving its OK.
Be very carefull
I had to have a new one and German and Swedish, don't do them.
Had to be BMW, £180 I think 2 years ago.
Be very carefull
I had to have a new one and German and Swedish, don't do them.
Had to be BMW, £180 I think 2 years ago.
-
tobias
- E30 Zone Regular

- Posts: 326
- Joined: Tue Aug 29, 2006 11:00 pm
- Location: isle of man
hey herman whats the best way of testing the fan
sorry im no mechanic
sorry im no mechanic
-
tobias
- E30 Zone Regular

- Posts: 326
- Joined: Tue Aug 29, 2006 11:00 pm
- Location: isle of man
cheers maxfieldmaxfield wrote:Cheaper here (clicky)
-
herman
- E30 Zone Regular

- Posts: 486
- Joined: Mon May 02, 2005 11:00 pm
- Location: Manchester
When you have stopped the fan should start as there is no air flow. Do that but keep an eye on the temp gauge if it does not kick in switch off.
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
3-5 miles is plenty of time for a BMW to be up to temp, and between half and three quarters is within spec on the gauge, although higher than most E30s normally sit.
Does the reading stay constant when it's up to temp?
In view of the price of a new stat, it might be worth getting an accurate temp reading from an external gauge, and/or inspecting the stat to see if there is anything obviously wrong.
Does the reading stay constant when it's up to temp?
In view of the price of a new stat, it might be worth getting an accurate temp reading from an external gauge, and/or inspecting the stat to see if there is anything obviously wrong.
-
m3-cab
- E30 Zone Newbie

- Posts: 33
- Joined: Mon Sep 04, 2006 11:00 pm
- Location: West Yorkshire
Mine seems to creep upto just below three quarters but then it just sits there. I suspect it might be the thermostatis switch kicking in the fan too late. As for warm up time, I'd say mine takes about the same amount of time to get to that temperature.
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Electric fan should be irrelevant when you are moving at any speed, especially in Manchester at this time of year.
Engine temp is set solely by the water thermostat. The electric fans job is to help keep the radiator water below that temp.
Engine temp is set solely by the water thermostat. The electric fans job is to help keep the radiator water below that temp.
-
herman
- E30 Zone Regular

- Posts: 486
- Joined: Mon May 02, 2005 11:00 pm
- Location: Manchester
I was in Devon at the time and its just a visual check to make sure the fan is working then you can move on to other causes.
-
tobias
- E30 Zone Regular

- Posts: 326
- Joined: Tue Aug 29, 2006 11:00 pm
- Location: isle of man
will have a look at both fan and stat for problems. mine gets up to three quarter mark and just stays there. was just a little concerned incase it shouldnt be that high or indeed up to that temp as fast as it is
-
Demlotcrew
- E30 Zone Team Member

- Posts: 13329
- Joined: Mon Dec 20, 2004 11:00 pm
- Location: East Anglia
Totally normal, mines heats up after only after a few miles also.
But if you note the temp of the oil that takes quite some time to get upto 80 deg.
All M3's i have worked on have had the needle sitting a few mil under the half way mark and in traffic on the half way mark or a little over.
HTH
A failed thermostat will cause the engine to run cold (on the quarter mark or lower)
I think you should have a look at the rad, make sure theres no leaves/dirt/missing veins.
Andrew
But if you note the temp of the oil that takes quite some time to get upto 80 deg.
All M3's i have worked on have had the needle sitting a few mil under the half way mark and in traffic on the half way mark or a little over.
HTH
A failed thermostat will cause the engine to run cold (on the quarter mark or lower)
I think you should have a look at the rad, make sure theres no leaves/dirt/missing veins.
Andrew
-
tobias
- E30 Zone Regular

- Posts: 326
- Joined: Tue Aug 29, 2006 11:00 pm
- Location: isle of man
hi andrew, mine sits just under 3/4 all the time. but you say a failed thermostat will make engine run cold. is there maybe a switch that may have gone or a sensor??
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Rad problem will make the car hotter when it is worked harder. Stats usually fail part open but not always.
If the temp is stable, but high, then it must be the stat or the gauge telling lies.
If the temp is stable, but high, then it must be the stat or the gauge telling lies.
-
tobias
- E30 Zone Regular

- Posts: 326
- Joined: Tue Aug 29, 2006 11:00 pm
- Location: isle of man
but brian have you heard andrews theory of the failed stat would make the engine run cold??
-
Demlotcrew
- E30 Zone Team Member

- Posts: 13329
- Joined: Mon Dec 20, 2004 11:00 pm
- Location: East Anglia
That would mean that the temp will also rise with 'load' on the engine.Brianmoooore wrote:Stats usually fail part open but not always.
I would just make sure the temp gauge is showing the correct temp.
Does your slow speed on the fan work?
Andrew
-
tobias
- E30 Zone Regular

- Posts: 326
- Joined: Tue Aug 29, 2006 11:00 pm
- Location: isle of man
not sure how to check andrew? 
-
Demlotcrew
- E30 Zone Team Member

- Posts: 13329
- Joined: Mon Dec 20, 2004 11:00 pm
- Location: East Anglia
Is the fan really noisy or just a whisper?
Andrew
Andrew
-
tobias
- E30 Zone Regular

- Posts: 326
- Joined: Tue Aug 29, 2006 11:00 pm
- Location: isle of man
the engine fan isnt excessively noisy
-
Demlotcrew
- E30 Zone Team Member

- Posts: 13329
- Joined: Mon Dec 20, 2004 11:00 pm
- Location: East Anglia
next test involves pulling out fuses 
-
tobias
- E30 Zone Regular

- Posts: 326
- Joined: Tue Aug 29, 2006 11:00 pm
- Location: isle of man
-
Demlotcrew
- E30 Zone Team Member

- Posts: 13329
- Joined: Mon Dec 20, 2004 11:00 pm
- Location: East Anglia
To turn the slow speed off by pulling the 15 amp fuse, then forcing the fan to kick in on the 'full' speed.
Fuse 3 for the slow speed
Fuse 18 for the high speed
Andrew
Fuse 3 for the slow speed
Fuse 18 for the high speed
Andrew
-
tobias
- E30 Zone Regular

- Posts: 326
- Joined: Tue Aug 29, 2006 11:00 pm
- Location: isle of man
and in doing so proves what? that the fan works on each speed? therfore the stat is the problem??
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Stat failed part open will make the engine run excessively cool when not under load, possibly rising to normal or above normal temp under load, depending on exactly how it has failed. The important thing is that a failed stat will give variable temps.
You need to determine if the car really is running too hot, or if it's just a gauge problem.
You need to determine if the car really is running too hot, or if it's just a gauge problem.


